Dynamite Friction 4302-59017 Disc Brake Kit - Rear

Rear Brake Kit for Civic, ILX, CSX, Prelude

Dynamite Friction DFC GEOSPEC Rotors with 3000 Ceramic Brake Pads, part number 4302-59017, is a rear disc brake kit built for select Honda and Acura applications. It combines coated rotors with low-dust ceramic pads for a service-ready brake replacement on compatible rear axle setups.

Key Features

• Rear disc brake kit with DFC GEOSPEC coated rotors and DFC 3000 ceramic brake pads
• Coated rotor surface helps resist rust and leaves the rotor dry and ready to install
• Non-directional rotor finish supports even pad bed-in and smoother braking
• Ceramic pad formulation targets stable friction, fade resistance, and low dust
• Post-cured and scorched pads reduce initial break-in time
• Rubber-steel-rubber shims help reduce noise, vibration, and harshness
• Part number 4302-59017 for easy identification

Product Details

The DFC GEOSPEC Rotors with 3000 Ceramic Brake Pads line is built as a complete brake service solution for rear axle replacement. The rotor design uses G3000/G11H18 cast iron and OE-style machining tolerances, while the coated finish adds corrosion protection without requiring extra prep before installation. The 3000 ceramic pads are formulated for passenger vehicles and light-duty trucks, with consistent friction across a wide temperature range and low-copper compliance for current regulations. This kit is a practical choice for drivers looking for a rear brake refresh on 2013-2015 Acura ILX, 2006-2015 Honda Civic, 2006-2007 Acura CSX, and 1997-2001 Honda Prelude applications. Part number 4302-59017 is also useful when cross-checking rear brake kit listings for the same vehicle coverage.

Common Brake Issues This Kit Can Address

• Rear brake pulsation from worn or uneven rotors
• Brake noise caused by aged pads or rotor surface wear
• Excess brake dust from older friction material
• Reduced stopping consistency from heat-affected pads
• Rust buildup on exposed rotor surfaces

Installation Notes and Tips

Confirm rear axle fitment before ordering and match the vehicle year, make, and model exactly. Clean the rotor friction surfaces only as needed during installation, and follow standard brake bedding procedures after service to help the pads and rotors seat evenly. Inspect caliper condition, slide hardware, and brake fluid condition during the job to complete the repair properly.

Quality Assurance

DFC GEOSPEC rotors are 100% inspected for critical dimensions and balance, and each rotor is backed by a 12-month warranty against defects in material and workmanship. The pads are post-cured and scorched for stable friction performance, and the kit is assembled to support OE-style brake service on the listed applications.