Dynamite Friction 4302-59049 Disc Brake Kit - Front

Front Brake Kit for 2009-2014 Honda Fit

Dynamite Friction DFC GEOSPEC Rotors with 3000 Ceramic Brake Pads, part number 4302-59049, is a front disc brake kit for 2009-2014 Honda Fit models. It combines coated rotors and ceramic pads for OE-style service replacement on the front axle.

Key Features

• Fits 2009-2014 Honda Fit, front
• DFC GEOSPEC coated rotors with a silver-gray corrosion-resistant finish
• DFC 3000 ceramic pads for stable friction and low dust operation
• Post-cured and scorched pad construction for consistent initial performance
• Rubber-steel-rubber shims help reduce brake noise, vibration, and harshness
• Rotors are machined to tight tolerances and finished with a non-directional surface
• Dry-pack rotor handling reduces prep time during installation

Product Details

The 4302-59049 brake kit is built for drivers servicing the front brakes on a Honda Fit. The DFC 3000 ceramic pads are formulated for reliable stopping performance, fade resistance, and stable friction across a wide temperature range. The pads are post cured and scorched to reduce break-in time, while the shim design supports quieter operation. The GEOSPEC rotors use a coated finish to resist rust better than conventional paint or zinc coatings, and the dry, ready-to-install packaging helps streamline brake service. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Reasons to Replace

• Brake pulsation or rotor wear on the front axle
• Reduced stopping performance during daily driving
• Brake dust buildup from worn pads
• Noise, squeal, or vibration from aging brake components
• Surface rust on rotors that affects appearance and service life

Installation Notes

Install on the front axle only for 2009-2014 Honda Fit applications listed for this kit. Clean the rotor friction surfaces before assembly if needed, and follow standard brake service procedures for pad bedding after installation. Verify caliper condition, slide hardware, and brake fluid level during service to complete the job correctly.

Quality Assurance

DFC rotors are manufactured to OE specifications, inspected for critical dimensions, and balanced where required. Each rotor includes a 12-month warranty against defects in material and workmanship. The brake pads are environmentally friendly and meet low-copper requirements referenced for California and Washington regulations.