Dynamite Friction 4312-03075 Disc Brake Kit - Front

Front Brake Kit for Hyundai and Kia

The Dynamite Friction DFC GEOSPEC Coated Rotors with 3000 Ceramic Brake Pads and Hardware Kit, part number 4312-03075, is a front disc brake kit built for select Hyundai and Kia applications. It combines coated rotors, ceramic pads, and brake hardware components for a complete front brake service on the listed vehicles.

Key Features

• Fits 2019-2021 Hyundai Veloster, front
• Fits 2016-2017 Hyundai Veloster, front
• Fits 2017-2018 Kia Forte, front
• Fits 2017-2018 Kia Forte5, front
• Fits 2017 Hyundai Elantra GT, front
• Fits 2017 Kia Forte Koup, front
• DFC 3000 ceramic pads with low dust and stable friction across a wide temperature range
• Post-cured and scorched pad construction for consistent initial braking response
• GEOSPEC coated rotors with a silver-gray finish that resists rust better than conventional paint or zinc coatings
• Non-directional rotor finish for smoother pad bed-in and quieter stops
• Brake hardware kit uses PTFE coating, vulcanized rubber, and stainless steel

Product Details

Part number 4312-03075 is a front brake service kit for the Hyundai Veloster, Kia Forte, Kia Forte5, Hyundai Elantra GT, and Kia Forte Koup applications listed above. The DFC 3000 ceramic pads are formulated for passenger cars and light-duty trucks, with emphasis on fade resistance, low dust output, and steady pedal feel. The pads are assembled with premium rubber-steel-rubber shims to help reduce noise, vibration, and harshness.

The GEOSPEC coated rotors are machined to OE-style tolerances from G3000/G11H18 cast iron, then finished with a non-directional surface to support even pad contact. They are processed dry and ready to install, which helps reduce prep time during brake service. The included hardware kit is designed to restore spring tension and caliper control where original hardware has worn or corroded. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues This Kit Can Address

• Brake noise from worn hardware or uneven pad contact
• Rust buildup on exposed rotor surfaces
• Excessive brake dust from older pad materials
• Reduced stopping consistency from heat-related fade
• Uneven wear caused by fatigued caliper hardware

Installation Notes

Use this kit on the front axle only for the listed vehicles. Inspect calipers, slides, and hoses before installation, and clean the hub mounting surface to help prevent rotor runout. Follow proper bedding procedures after installation to promote even pad transfer and stable braking performance. Part number 4312-03075 is intended for direct replacement on the confirmed fitments shown above.

Quality Assurance

DFC rotors are inspected for critical dimensions and balance during production, and each rotor is covered by a 12-month warranty against defects in material and workmanship. The brake pads are post-cured and scorched to support stable friction performance from the first stop.