Dynamite Friction 4312-54064 Disc Brake Kit - Rear

Rear Brake Kit for 2010-2011 Ford Ranger

Dynamite Friction DFC GEOSPEC Coated Rotors with 3000 Ceramic Brake Pads and Hardware Kit, part number 4312-54064, is a rear disc brake service kit for the 2010-2011 Ford Ranger. It combines coated rotors, ceramic pads, and matched brake hardware for a complete rear brake refresh on the Ranger platform.

Key Features

• Fits 2010-2011 Ford Ranger, rear
• DFC 3000 ceramic brake pads for stable friction and low dust
• Post-cured and scorched pad construction for consistent initial performance
• Premium rubber-steel-rubber shims for improved noise, vibration, and harshness control
• GeoSpec coated rotors with a silver-gray finish that resists rust better than conventional paint or zinc coatings
• Dry-packed rotors arrive ready to install without oil removal
• Non-directional rotor finish supports even pad bed-in and quieter stops
• Hardware kit uses PTFE coating, vulcanized rubber, and stainless steel

Product Details

The 4312-54064 brake kit is built for rear service on the Ford Ranger and is designed around OE-style fit, finish, and braking behavior. The DFC 3000 ceramic pads are formulated for passenger vehicles and light-duty trucks, with low copper content to meet current environmental requirements. The GeoSpec rotors are machined to tight tolerances from G3000/G11H18 cast iron, then inspected for balance and critical dimensions to support reliable braking performance. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues This Kit Can Address

• Rear brake noise during stops
• Excessive brake dust buildup on wheels
• Rust on rotor surfaces after storage or exposure
• Uneven pad wear caused by fatigued hardware
• Reduced braking consistency from worn rear components

Installation Notes

Compatible With 2010-2011 Ford Ranger rear brake service. Clean mounting surfaces before installation, verify caliper operation, and follow proper pad bed-in procedures after assembly. The rotors are shipped dry and ready to install, which reduces prep time during the brake job. Part number 4312-54064 should be matched to the rear axle application only.

Quality Assurance

Each DFC GeoSpec rotor is 100% inspected for critical dimensions and balance, and every rotor is covered by a 12-month warranty against defects in material and workmanship. The brake pads are post-cured and scorched for stable friction performance, and the hardware kit is engineered to OE-style form, fit, and function.