Dynamite Friction 4504-74013 Disc Brake Kit - Front and Rear

Brake Kit for 2010 Volkswagen Jetta

This Dynamite Friction brake service kit combines DFC GEOSPEC coated rotors with 5000 Advanced brake pads for the front and rear of the 2010 Volkswagen Jetta. It is built for drivers looking for a direct brake service solution with OE-style rotor construction and application-specific pad friction.

Key Features

• Disc brake kit with rotors and pads for front and rear service
• Fits 2010 Volkswagen Jetta, front and rear
• DFC GEOSPEC rotors feature a silver-gray corrosion-resistant coating
• Rotors are shipped dry and ready to install
• Non-directional rotor finish supports even pad bed-in and quieter stops
• 5000 Advanced pads are post-cured and scorched for stable friction performance
• Premium rubber-steel-rubber shims help reduce noise, vibration, and harshness
• Part number 4504-74013

Product Details

The DFC GEOSPEC Rotors with 5000 Advanced Brake Pads line is engineered as a complete brake service package for vehicles that need matched rotor and pad components. The rotors use G3000/G11H18 cast iron and are machined to tight tolerances, then finished with a non-directional surface to promote consistent contact during break-in. The coated surface helps resist rust better than conventional paint or zinc finishes, while the dry packaging avoids the need to clean oil from the rotor before installation. The 5000 Advanced pads are formulated for stable friction, with post-curing, scorching, and NVH-focused shims to support smoother operation. Part number 4504-74013 is listed for the 2010 Volkswagen Jetta, front and rear.

Common Brake Issues This Kit Can Address

• Brake pulsation from worn or uneven rotors
• Rust buildup on exposed rotor surfaces
• Noise during braking from aged pads or hardware wear
• Reduced stopping consistency from heat-cycled friction material
• Extended service time caused by unprepared rotor surfaces

Installation Notes

Fits 2010 Volkswagen Jetta, front and rear. Confirm rotor size, brake package, and axle configuration before installation. The rotors are dry and ready to install, which can reduce prep time during brake service. Follow standard brake bedding procedures after installation to help the pads and rotors seat evenly. Part number 4504-74013 may also be referenced during parts lookup for the same application.

Quality Assurance

DFC states that each rotor is inspected for critical dimensions and balance, with vented rotors electronically mill-balanced when required. The rotors are manufactured to OE specifications and include a 12-month warranty against defects in material and workmanship.