Dynamite Friction 4512-31238 Disc Brake Kit - Rear

Rear Brake Kit for BMW 535i GT and 740Li

The Dynamite Friction DFC GEOSPEC Coated Rotors with 5000 Advanced Brake Pads - Ceramic and Hardware kit is a rear disc brake service solution for select BMW applications. Part number 4512-31238 combines coated rotors, ceramic brake pads, and brake hardware for a complete rear brake refresh on covered 2010-2017 BMW models.

Key Features

• Rear disc brake kit with GEOSPEC coated rotors, 5000 Advanced ceramic pads, and hardware
• Fits 2010-2017 BMW 535i GT, rear
• Fits 2011-2017 BMW 535i GT xDrive, rear
• Fits 2011-2015 BMW 740Li, rear
• Fits 2013-2015 BMW 740Li xDrive, rear
• Fits 2013-2015 BMW ActiveHybrid 7, rear
• Fits 2015 BMW 740Ld xDrive, rear
• GEOSPEC coating helps resist rust and arrives dry for installation
• Rotors are machined to OE-style tolerances with a non-directional finish
• Brake pads are post-cured, scorched, and paired with premium shims for improved NVH control
• Hardware uses PTFE coating, vulcanized rubber, and stainless steel construction

Product Details

DFC builds this brake service kit around OE-focused friction and rotor specifications for rear axle applications. The coated rotors use G3000/G11H18 cast iron and a silver-gray protective finish that helps fight corrosion while reducing prep time because the rotors are shipped dry and ready to install. The 5000 Advanced ceramic pads are post-cured for stable friction performance and scorched to reduce initial break-in needs. DFC also includes hardware designed to restore proper spring tension and caliper movement on worn rear brake assemblies. Part number 4512-31238 is a practical choice for BMW 535i GT, BMW 740Li, and related rear brake service jobs where rotor finish, pad consistency, and hardware condition all matter.

Common Brake Issues This Kit Can Address

• Rear brake noise from worn pads or fatigued hardware
• Rust buildup on exposed rotor surfaces
• Uneven rear pad wear caused by aged clips or hardware
• Brake pulsation related to worn or out-of-spec rotors
• Reduced stopping consistency from depleted rear brake components

Installation Notes and Tips

Verify rear rotor design before ordering, since some listed BMW applications note aluminum hat rotor configurations while others note full cast rotor designs. Inspect calipers, pad wear sensors, and mounting surfaces during service, and clean the hub face before installing the new rotors. The coated surface is designed to be swept away by the pads during normal braking.

Quality Assurance

Each DFC GEOSPEC rotor is 100% inspected for critical dimensions and balance, with vented rotors electronically mill-balanced when required. The rotors carry a 12-month warranty against defects in material and workmanship. Part number 4512-31238 is built to OE-style expectations for rear brake service on select BMW applications.