Dynamite Friction 4514-02019 Disc Brake Kit - Front and Rear

Brake Kit for Porsche 911

Dynamite Friction DFC Geospec Rotors with 5000 Advanced Brake Pads includes Hardware, part number 4514-02019, is a complete disc brake kit for select Porsche 911 applications. It combines coated rotors, advanced friction pads, and matching hardware for a service-focused brake replacement on 1975-1983 Porsche 911 models.

Key Features

• Complete disc brake kit with rotors, pads, and hardware
• Fits 1978-1983 Porsche 911, front and rear, without Turbo-Look Package
• Fits 1975-1977 Porsche 911, front and rear, with front cast iron “A” calipers
• GeoSpec rotors use a silver-gray protective coating to resist rust
• Rotors are shipped dry and ready to install
• Non-directional rotor finish supports even pad bed-in and quieter stops
• 5000 Advanced pads are post-cured and scorched for stable friction performance
• Premium rubber-steel-rubber shims are used to improve NVH control
• Hardware kit uses PTFE coating, vulcanized rubber, and stainless steel

Product Details

The DFC Geospec Rotors with 5000 Advanced Brake Pads package is built around OE-style service requirements for the Porsche 911. The rotors are cast to G3000/G11H18 specifications, machined to tight tolerances, and inspected for critical dimensions and balance. The pad formulation is prepared for consistent friction behavior, while the included hardware is designed to restore proper caliper movement and reduce noise-related wear issues. Part number 4514-02019 is a direct service solution for Porsche 911 brake maintenance where rotor, pad, and hardware replacement are needed together.

Common Brake Issues Addressed

• Brake noise from worn or fatigued hardware
• Uneven pad wear caused by corroded or weak hardware components
• Rust buildup on exposed rotor surfaces
• Longer stopping distances from worn friction material
• Vibration or harshness during braking

Installation Notes

Verify caliper type and model-year fitment before installation. This kit is listed for 1978-1983 Porsche 911, front and rear, without Turbo-Look Package, and for 1975-1977 Porsche 911, front and rear, with front cast iron “A” calipers. Clean the rotor friction surfaces before assembly, follow proper torque procedures, and complete a full brake bed-in cycle after installation. Part number 4514-02019 should be matched to the exact vehicle configuration shown in the fitment data.

Quality Assurance

DFC states that each rotor is 100% inspected after machining to confirm critical specifications, and every rotor includes a 12-month warranty against defects in material and workmanship. The brake pads are post-cured, scorched, and assembled with premium shims to support consistent service performance. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.