Dynamite Friction 4514-21020 Disc Brake Kit - Front and Rear

Brake Kit for Hyundai Nexo

The Dynamite Friction DFC Geospec Rotors with 5000 Advanced Brake Pads kit is built for 2019-2025 Hyundai Nexo front and rear brake service. It combines coated rotors, advanced friction pads, and brake hardware in one service kit for a complete brake refresh.

Key Features

• Fits 2019-2025 Hyundai Nexo, front and rear
• DFC 5000 Advanced Brake Pads with post-cured friction material
• Scorched pad surface to reduce initial break-in time
• Premium rubber-steel-rubber shims for improved noise, vibration, and harshness control
• GeoSpec coated rotors with a silver-gray corrosion-resistant finish
• Dry-processed rotors arrive ready to install
• Non-directional rotor finish for more even pad bed-in and smoother braking
• Part number 4514-21020

Product Details

This DFC brake service kit is engineered for the Hyundai Nexo and pairs OE-style rotor construction with advanced pad friction and matched hardware. The rotors use G3000/G11H18 cast iron and are machined to tight tolerances, then finished with a non-directional surface to support consistent pad contact. The coated rotor surface helps resist rust while simplifying brake service on the 2019-2025 Hyundai Nexo. Part number 4514-21020 is a direct fit for front and rear brake maintenance on this application.

The DFC 5000 Advanced Brake Pads are post cured for stable friction performance and assembled with premium shims to help reduce brake noise and vibration. This makes the kit a practical choice for Hyundai Nexo brake repair when you want matched components from one source. Part number 4514-21020 is also a useful reference when ordering the correct Hyundai Nexo brake kit.

Common Brake Issues This Kit Can Address

• Brake noise from worn pads or fatigued hardware
• Uneven pad wear caused by corroded or weakened hardware
• Reduced stopping performance from worn rotors and pads
• Rotor rust and surface corrosion on daily-driven vehicles
• Longer brake service time from uncoated rotors that require prep

Installation Notes

Inspect calipers, slides, and mounting points before installation. Clean the hub face thoroughly, verify rotor seating, and follow proper torque procedures during assembly. Because the rotors are shipped dry and ready to install, no additional rotor preparation is required before service. For best results, complete a proper pad bed-in procedure after installation.

Quality Assurance

DFC GeoSpec rotors are 100% inspected for critical dimensions and balance, with vented rotors electronically mill-balanced when needed. The rotors are covered by a 12-month warranty against defects in material and workmanship.