Dynamite Friction 4514-27005 Disc Brake Kit - Front and Rear

Brake Kit for Volvo 240, DL, and GLE

The Dynamite Friction DFC GEOSPEC Coated Rotors with 5000 Advanced Brake Pads and hardware kit is a complete disc brake service kit for select Volvo applications. It combines coated rotors, low metallic pads, and brake hardware in one package for front and rear service on the listed vehicles.

• Complete disc brake kit with rotors, pads, and hardware components
• GEOSPEC coated rotors with a silver-gray corrosion-resistant finish
• Dry-to-install rotor coating reduces prep time during brake service
• 5000 Advanced low metallic pads are post-cured and scorched for stable friction
• Premium rubber-steel-rubber shims help reduce noise, vibration, and harshness
• Non-directional rotor finish supports even pad bed-in and smoother stops
• OE-style rotor machining and inspection for dimensional consistency

Product Line Details

DFC Complete Brake Kits are built to simplify brake service by combining matched friction components for the axle being serviced. The GEOSPEC rotor line uses a coated finish to resist rust better than conventional paint or zinc-style coatings, while the 5000 Advanced pad formulation is developed for consistent friction performance across a wide range of vehicle applications. Part number 4514-27005 is part of this coordinated brake service lineup.

Fitment and Application

• Fits 1990-1993 Volvo 240, front and rear.
• Fits 1984 Volvo DL, front and rear; vented front rotors; with ATE brakes.
• Fits 1984 Volvo GLE, front and rear; vented front rotors; with ATE brakes.

This part number, 4514-27005, is a direct fit for the listed Volvo brake service applications and is also referenced as 4514-27005 in catalog listings.

What This Brake Kit Helps Address

• Brake noise from worn pads or fatigued hardware
• Uneven pad wear caused by corroded or weakened hardware
• Rotor rust buildup on vehicles exposed to moisture and road salt
• Longer stopping distances from worn friction components
• Brake pulsation or rough braking feel from worn rotors

Installation Notes

Install on the specified axle position only and verify rotor and caliper hardware condition before assembly. The rotors are shipped dry and ready to install, which helps reduce prep time during service. For best results, clean all mating surfaces, follow the vehicle service manual, and perform a proper pad bed-in procedure after installation.

Quality Assurance

DFC GEOSPEC rotors are machined to tight tolerances, finished with a non-directional surface, and individually inspected for critical dimensions and balance. The rotors carry a 12-month warranty against defects in material and workmanship.