Dynamite Friction 4514-27044 Disc Brake Kit - Front and Rear

Brake Kit for Volvo C70 and S70

The Dynamite Friction DFC GEOSPEC Coated Rotors with 5000 Advanced Brake Pads - Low Metallic and Hardware Kit is a front and rear disc brake kit built for select Volvo applications. Part number 4514-27044 combines coated rotors, low metallic pads, and brake hardware components in one service package for a cleaner brake replacement on compatible vehicles.

Key Features

• DFC GEOSPEC coated rotors with a silver-gray corrosion-resistant finish
• 5000 Advanced low metallic brake pads with post-cured friction material
• Scorched pad surface to reduce initial break-in time
• Premium rubber-steel-rubber shims for improved NVH control
• Non-directional rotor finish for more even pad bed-in and quieter stops
• OE-style rotor machining and inspection for dimensional consistency
• Hardware kit included for the listed applications

Product Details

DFC’s 5000 Advanced pad line is formulated for modern braking systems that require stable friction characteristics and consistent pedal response. The pads are post cured, then scorched to remove uncured bonding agents, which helps reduce the need for extended bedding procedures. On the rotor side, the GeoSpec coating is designed to resist rust better than conventional paint or zinc finishes, and the rotors are shipped dry and ready to install. Part number 4514-27044 is a practical choice for Volvo C70 and Volvo S70 brake service where OE-style fit, finish, and noise control matter.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Vehicle Fitment

• Fits 1998 Volvo S70, front and rear. Notes: 302mm front rotors; DFC GEOSPEC Coated Rotors with 5000 Advanced Brake Pads - Low Metallic and Hardware Kit.
• Fits 1998-2004 Volvo C70, front and rear. Notes: 302mm front rotors; DFC GEOSPEC Coated Rotors with 5000 Advanced Brake Pads - Low Metallic and Hardware Kit.

Installation Notes

Before installation, confirm rotor diameter and brake configuration against the vehicle’s existing setup. Clean the hub mounting surface, inspect calipers and slides, and follow proper torque procedures during assembly. The coated rotor surface does not require pre-cleaning, but the friction surface should be handled carefully to avoid contamination. After installation, perform a controlled bedding procedure to establish even pad transfer.

Quality Assurance

DFC GeoSpec rotors are machined to tight tolerances, finished with a non-directional surface, and inspected for balance and critical dimensions. The rotors carry a 12-month warranty against defects in material and workmanship.