Dynamite Friction 4514-63017 Disc Brake Kit - Front and Rear

Brake Kit for Mercedes-Benz E500

Restore confident stopping performance on your 2004-2005 Mercedes-Benz E500 with this complete disc brake kit from Dynamite Friction. Part number 4514-63017 combines DFC Geospec coated rotors, 5000 Advanced brake pads, and matching hardware for front and rear service.

Key Features

• Fits 2004-2005 Mercedes-Benz E500, front and rear
• DFC Geospec coated rotors with a silver-gray corrosion-resistant finish
• 5000 Advanced brake pads with post-cured friction material
• Scorched pad surface for reduced initial break-in
• Premium rubber-steel-rubber shims for improved noise, vibration, and harshness control
• Non-directional rotor finish for more even pad bed-in and smoother braking
• Part number 4514-63017 for direct application lookup

Product Details

The DFC Geospec Rotors with 5000 Advanced Brake Pads kit is built for OE-style service on the Mercedes-Benz E500. The rotors are machined to tight tolerances, processed dry, and ready to install, while the pad compound is formulated for stable friction performance and consistent pedal feel. This kit is intended for drivers replacing worn brake components on the front and rear axles of the 2004-2005 Mercedes-Benz E500.

DFC Geospec rotors use G3000/G11H18 cast iron and a protective coating that helps resist rust better than conventional painted or zinc-coated rotors. The rotor surfaces receive a non-directional finish to support even pad contact and quieter operation. Part number 4514-63017 is a practical choice for a full brake service on the Mercedes-Benz E500.

Common Brake Service Issues

• Brake pulsation from worn or uneven rotors
• Squealing or noise from fatigued hardware or pad wear
• Reduced stopping response from aged friction material
• Corrosion on rotor hats and non-friction surfaces
• Uneven pad wear caused by stressed brake hardware

Installation Notes

Inspect calipers, slides, and brake hoses before installation. Clean the hub mounting surface thoroughly so the new rotors seat flat, and follow the vehicle service procedure for pad bedding after installation. Because this kit is specified for the front and rear positions on the 2004-2005 Mercedes-Benz E500, verify axle location before ordering.

Quality Assurance

Each rotor is 100% inspected for critical dimensions and balance, and every rotor carries a 12-month warranty against defects in material and workmanship. DFC pads are post-cured, scorched, and assembled with premium shims to support consistent friction and NVH control. Part number 4514-63017 is engineered to meet OE-style requirements for this application.