Dynamite Friction 4514-67031 Disc Brake Kit - Front and Rear

Brake Kit for Nissan Rogue Select and X-Trail

Dynamite Friction DFC GEOSPEC Coated Rotors with 5000 Advanced Brake Pads - Ceramic and Hardware, part number 4514-67031, is a complete disc brake kit for front and rear service. It is built for 2014-2015 Nissan Rogue Select and 2008-2014 Nissan X-Trail applications, with rotors, pads, and hardware components matched for a full brake refresh.

Key Features

• Complete disc brake kit for front and rear service
• DFC GEOSPEC coated rotors with dry, ready-to-install finish
• G3000/G11H18 cast iron rotor construction
• Non-directional rotor finish for even pad bed-in and smoother braking
• 5000 Advanced ceramic brake pads with post-cured friction material
• Premium rubber-steel-rubber shims for improved noise and vibration control
• Hardware kit uses PTFE coating, vulcanized rubber, and stainless steel
• Part number 4514-67031

Product Details

The DFC GEOSPEC rotor line is engineered to OE specifications for durability, stability, and consistent braking performance. The coated surface helps resist rust better than conventional paint or zinc finishes, and the rotors are processed dry so they can be installed without extra cleaning or prep. The 5000 Advanced pads are post cured and scorched to reduce initial break-in time, while the included hardware is designed to restore proper caliper movement and spring tension. This makes 4514-67031 a practical choice for Nissan Rogue Select and Nissan X-Trail brake service when you want a full rotor, pad, and hardware replacement in one package.

Common Brake Issues This Kit Can Address

• Brake noise from worn pads or fatigued hardware
• Uneven pad wear caused by corroded or stressed hardware
• Reduced stopping consistency from worn rotors
• Rust buildup on exposed rotor surfaces
• Excessive caliper movement from aged brake hardware

Installation Notes

Fits 2014-2015 Nissan Rogue Select, front and rear. Fits 2008-2014 Nissan X-Trail, front and rear. Verify axle position before ordering and inspect calipers, slides, and brake fluid condition during service. The dry-coated rotors are ready for installation, and the non-directional finish supports a more even pad bed-in after assembly. Part number 4514-67031 should be matched to the vehicle’s brake configuration before installation.

Quality Assurance

Each DFC GEOSPEC rotor is machined to tight tolerances, balanced where required, and inspected for critical dimensions to meet OE specifications. DFC states that the rotors carry a 12-month warranty against defects in material and workmanship.