Dynamite Friction 4514-68002 Disc Brake Kit - Front and Rear

Brake Kit for Brembo-Equipped Nissan and INFINITI

Dynamite Friction DFC GEOSPEC Coated Rotors with 5000 Advanced Brake Pads - Low Metallic and Hardware Kit, part number 4514-68002, is a complete disc brake kit for select Brembo-equipped applications. It combines coated rotors, advanced low-metallic pads, and matching hardware components for a service-focused brake replacement.

Key Features

• Fits 2003-2008 Nissan 350Z, front and rear, Brembo brakes
• Fits 2003-2004 INFINITI G35, front and rear, Brembo brakes
• DFC GEOSPEC coated rotors with dry-to-install finish
• 5000 Advanced low-metallic brake pads with post-cured friction material
• Premium rubber-steel-rubber shims for improved NVH control
• Hardware kit uses PTFE coating, vulcanized rubber, and stainless steel
• Part number 4514-68002

Product Details

The DFC GEOSPEC rotor line is built to OE-style dimensions and machined to tight tolerances for stable braking performance. The coated surface helps resist rust and arrives ready to install without oil removal, which can reduce prep time during brake service. The rotors use G3000/G11H18 cast iron and a non-directional finish to support even pad bed-in and smoother stopping.

The 5000 Advanced brake pads are post cured and scorched to reduce initial break-in time and deliver consistent friction from the first stop. DFC also pairs the pads with premium shims to help reduce brake noise and vibration. The included hardware kit is designed to restore spring tension and caliper movement control on worn brake assemblies. Part number 4514-68002 is a direct service solution for Nissan 350Z and INFINITI G35 Brembo brake maintenance.

What This Brake Kit Helps Address

• Brake noise from worn pads or fatigued hardware
• Uneven pad wear caused by corroded or weakened clips and springs
• Longer stopping distances from worn rotors and friction material
• Brake vibration or harshness during everyday driving
• Rust buildup on rotor surfaces and brake components

Installation Notes

Verify Brembo brake configuration before ordering. This kit is listed for front and rear service on the specified vehicles, so match the application to the axle being serviced. Clean all mating surfaces before installation, inspect calipers and guide hardware for wear, and follow the vehicle manufacturer’s torque and bedding procedures after installation.

Quality Assurance

DFC states that each rotor is inspected for critical dimensions and balance, with vented rotors corrected as needed during production. The rotors carry a 12-month warranty against defects in material and workmanship. Part number 4514-68002 is built for OE-style fit, finish, and service consistency.