Dynamite Friction 4514-72009 Disc Brake Kit - Front and Rear

Brake Kit for Chrysler, Dodge, and Mitsubishi

The Dynamite Friction DFC GEOSPEC Coated Rotors with 5000 Advanced Brake Pads and hardware kit is a front and rear disc brake kit built for OE-style service on select Chrysler, Dodge, and Mitsubishi vehicles. Part number 4514-72009 combines coated rotors, ceramic brake pads, and brake hardware in one package for a complete brake refresh.

Compatible With 2001-2005 Chrysler Sebring, front and rear; 2001-2005 Dodge Stratus, front and rear; 2001-2005 Mitsubishi Eclipse, front and rear; and 2000-2003 Mitsubishi Galant, front and rear.

Key Features

• Disc brake kit with GEOSPEC coated rotors, 5000 Advanced ceramic pads, and hardware
• Dry, ready-to-install rotors with a silver-gray corrosion-resistant coating
• Non-directional rotor finish for more even pad bed-in and smoother braking
• 100% post-cured pads for stable friction performance
• Scorched pad surface to reduce initial break-in time
• Premium rubber-steel-rubber shims for improved noise, vibration, and harshness control
• OE-style rotor machining and inspection for dimensional consistency

Product Details

DFC GEOSPEC rotors are cast to G3000/G11H18 specifications, machined to tight tolerances, and inspected for balance and critical dimensions. The coated finish helps resist rust better than conventional paint or zinc coatings, while the dry packaging eliminates the need to clean oil from the rotor before installation. The 5000 Advanced brake pads are formulated for stable friction and consistent pedal response, and the included hardware uses PTFE coating, vulcanized rubber, and stainless steel construction for proper caliper movement and fit.

This part number, 4514-72009, is a practical choice for drivers searching for a 2001-2005 Chrysler Sebring brake kit, 2001-2005 Dodge Stratus front and rear brake kit, or a Mitsubishi Eclipse and Galant rotor and pad service kit.

Common Brake Service Issues

• Brake noise from worn pads or fatigued hardware
• Pulsation or uneven braking from worn rotors
• Rust buildup on exposed rotor surfaces
• Longer stopping distances caused by worn friction material
• Uneven pad wear from aged clips and hardware

Installation Notes

Before installation, verify axle position and vehicle fitment against the application list. The rotors are shipped dry and ready to install, which can reduce prep time during a brake job. For best results, follow proper brake service procedures, clean mating surfaces, and complete a controlled pad bed-in after installation. Part number 4514-72009 is listed for front and rear service on the vehicles shown above.

Quality Assurance

Each rotor is 100% inspected after machining to confirm critical specifications, and vented rotors are electronically mill-balanced when required. DFC brake pads are post-cured and scorched for stable performance, and the rotors carry a 12-month warranty against defects in material and workmanship.