Dynamite Friction 4514-74053 Disc Brake Kit - Front and Rear

Brake Kit for 2005 Volkswagen Jetta

Dynamite Friction DFC GEOSPEC Coated Rotors with 5000 Advanced Brake Pads and hardware kit, part number 4514-74053, is a front and rear disc brake kit for the 2005 Volkswagen Jetta. It combines coated rotors, low metallic pads, and matching brake hardware for a complete service-style brake replacement.

Key Features

• Fits 2005 Volkswagen Jetta, front and rear
• DFC GEOSPEC coated rotors with a silver-gray corrosion-resistant finish
• Dry-processed, dry-shipped rotors ready for installation
• G3000/G11H18 cast iron rotor construction for OE-style durability and stability
• Non-directional rotor finish for even pad bed-in and smoother braking
• DFC 5000 Advanced low metallic brake pads with post-cured and scorched friction material
• Premium rubber-steel-rubber shims for improved noise, vibration, and harshness control
• Hardware kit uses PTFE coating, vulcanized rubber, and stainless steel
• Part number 4514-74053

Product Details

This DFC brake service kit is built for drivers servicing a 2005 Volkswagen Jetta brake system with matched components in one package. The coated rotors are machined to tight tolerances, inspected for critical dimensions, and balanced where required to support consistent braking performance. The 5000 Advanced pads are formulated for stable friction and reduced initial break-in, while the included hardware kit addresses worn or corroded brake hardware that can contribute to noise and uneven wear. Part number 4514-74053 is a direct fit for the listed front and rear application on the 2005 Volkswagen Jetta.

Common Brake Issues This Kit Can Address

• Rotor rust and surface corrosion
• Brake noise from worn hardware or pad shims
• Uneven pad wear from fatigued hardware
• Longer stopping distances caused by worn friction material
• Brake pulsation related to rotor wear or finish issues

Installation Notes

Verify vehicle production date before ordering, since this 2005 Volkswagen Jetta application is listed for vehicles produced from 1/05 to 11/05 and from 11/05 onward. Clean all mating surfaces before installation, follow proper torque specifications, and complete a careful bed-in procedure for the new pads and rotors. The rotors are shipped dry and ready to install, so no oil removal step is required.

Quality Assurance

DFC states that each rotor is inspected to confirm OE-spec critical dimensions and that vented rotors are balance-checked and corrected when needed. The rotors carry a 12-month warranty against defects in material and workmanship.