Dynamite Friction 4514-75021 Disc Brake Kit - Front and Rear

Brake Kit for Lexus LS460 and LS600h

The DFC GEOSPEC Coated Rotors with 5000 Advanced Brake Pads and hardware kit is a front and rear disc brake kit built for select Lexus LS models. Part number 4514-75021 combines coated rotors, low metallic pads, and matched brake hardware for a complete brake service on the same axle set.

• Fits 2009-2017 Lexus LS460, front and rear
• Fits 2008-2016 Lexus LS600h, front and rear
• Fits 2007-2009 Lexus LS460 with Touring Package, front and rear
• DFC GEOSPEC coated rotors with dry-to-install finish
• 5000 Advanced low metallic brake pads with post-cured friction material
• Premium rubber-steel-rubber shims for improved noise and vibration control
• Hardware kit with PTFE coating, vulcanized rubber, and stainless steel construction

Product Line Details

DFC Complete Brake Kits are assembled to simplify brake service by pairing rotors, pads, and hardware in one application-specific package. The GeoSpec rotor finish is designed to resist rust better than conventional paint or zinc coatings, while the non-directional machined surface supports even pad bed-in and smoother braking. The 5000 Advanced pad formulation is scorched and post cured to reduce initial break-in time and deliver stable friction performance from the first stop.

For Lexus LS460 and Lexus LS600h brake replacement, this kit provides the core components needed for a full front and rear brake refresh. Part number 4514-75021 is a direct fit for the listed applications and is suited for drivers replacing worn rotors, pads, and brake hardware at the same time.

Common Brake Issues This Kit Addresses

• Brake pulsation from worn or uneven rotors
• Squealing or noise caused by aged pad and hardware components
• Reduced stopping performance from worn friction material
• Corrosion on rotor surfaces and brake hardware
• Uneven pad wear from fatigued clips or caliper hardware

Installation Notes and Tips

Verify vehicle fitment by year, model, and package before installation. Clean the rotor surfaces only as needed before service; GeoSpec rotors are shipped dry and ready to install. Inspect caliper slides, pads, and mounting points during brake service, and follow the vehicle manufacturer’s torque and bedding procedures after installation.

Quality Assurance

DFC machines the rotors to tight tolerances, applies a non-directional finish, and inspects critical dimensions to OE specifications. Vented rotors are balance-checked, and the rotors carry a 12-month warranty against defects in material and workmanship. The brake pads are post cured, scorched, and assembled with premium shims to support stable friction and quieter operation.