Dynamic Friction 600-01006 Disc Brake Rotor - Rear

DFC Brake Rotor Overview

The Dynamic Friction DFC Brake Rotor, part number 600-01006, is a solid disc brake rotor built around the dimensions needed for a direct brake service replacement. With a 278 mm outside diameter, 46.3 mm height, 5-bolt pattern, and 12.6 mm bolt hole diameter, it is specified for applications that require this exact rotor geometry.

Use this DFC Brake Rotor 600-01006 when servicing brake systems that call for a solid rotor with an 11 mm discard thickness and 12 mm nominal thickness. It is a practical choice for brake repair on vehicles such as Honda Civic and Toyota Corolla applications where the rotor specification must match the original setup.

Key Features

• Part number: 600-01006
• DFC Brake Rotor from Dynamic Friction
• Solid disc brake rotor design
• 278 mm outside diameter for specified brake applications
• 46.3 mm overall height
• 5-bolt hole configuration with 12.6 mm bolt hole diameter
• 62 mm inside diameter
• 11 mm discard thickness and 12 mm nominal thickness

Detailed Description

The DFC Brake Rotor line focuses on replacement rotors for brake service where dimensional accuracy matters. This rotor is a solid type, not vented, and is defined by its 278 mm outside diameter, 62 mm inside diameter, and 46.3 mm height. Those measurements help ensure the rotor matches the vehicle’s hub and brake package requirements before installation.

For fitment-based searches, this rotor is relevant to drivers looking for a brake rotor for Honda Civic or Toyota Corolla brake repair, especially when the application calls for a 5-lug solid rotor. The part number 600-01006 should be verified against the vehicle’s original rotor dimensions and brake system specifications before ordering.

What This Rotor Helps Address

• Brake pulsation caused by rotor wear or thickness variation
• Rotor scoring or surface damage from normal brake use
• Reduced braking performance from a rotor below discard thickness
• Noise related to worn or uneven rotor surfaces
• Brake service needs on vehicles requiring a solid 5-bolt rotor

Installation Notes and Tips

Confirm outside diameter, inside diameter, height, bolt hole quantity, and bolt hole diameter against the removed rotor before installation. Measure the existing rotor to verify it is above the 11 mm discard thickness threshold and matches the 12 mm nominal thickness specification. Clean the hub mounting surface thoroughly and inspect pads, calipers, and hardware condition during brake service.

Because fitment data is not provided in the catalog record, confirm application details by VIN or by matching the original rotor dimensions. If your vehicle uses a Honda Civic or Toyota Corolla brake setup, compare the OE rotor measurements carefully before installation.

Quality Assurance

Dynamic Friction’s DFC Brake Rotor line is built for replacement brake service where dimensional consistency is important. Part number 600-01006 should be matched to the vehicle’s brake specification to support proper fit and function.