Dynamic Friction 600-03034 Disc Brake Rotor - Front

Front Vented Brake Rotor for Genesis Coupe

The Dynamic Friction DFC Brake Rotor 600-03034 is a front disc brake rotor built for 2010-2016 Hyundai Genesis Coupe applications with Mando Brakes 1-piston calipers. It uses a vented rotor design and the listed dimensions to match the specified fitment and braking setup.

Key Features

• Brand: Dynamic Friction
• Brand line: DFC Brake Rotor
• Part number: 600-03034
• Front disc brake rotor for Hyundai Genesis Coupe
• Vented rotor construction for front axle use
• Outside diameter: 320 mm
• Nominal thickness: 28 mm
• Discard thickness: 26.4 mm
• Height: 56.7 mm
• Bolt hole quantity: 5
• Bolt hole diameter: 12.5 mm
• Inside diameter: 69 mm

DFC Brake Rotor Line Details

The DFC Brake Rotor line focuses on direct-fit brake rotor replacements with application-specific dimensions. For this Hyundai Genesis Coupe front rotor, the listed measurements and vented design support a precise match to the specified braking configuration.

Detailed Description

Fits 2010-2016 Hyundai Genesis Coupe, front, with Mando Brakes 1-piston calipers. The Dynamic Friction 600-03034 rotor is specified with a 320 mm outside diameter, 28 mm nominal thickness, and 26.4 mm discard thickness, along with a 56.7 mm height and 5-bolt mounting pattern. These dimensions are important when replacing a front brake rotor on the Hyundai Genesis Coupe and when verifying rotor-to-caliper and hub fitment. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Issues This Rotor Can Address

• Front brake pulsation caused by rotor wear or thickness variation
• Brake noise related to worn or heat-affected rotor surfaces
• Reduced braking consistency from a rotor below discard thickness
• Service replacement needs for a front Hyundai Genesis Coupe brake rotor
• Fitment correction when replacing a rotor on Mando Brakes 1-piston caliper setups

Installation Notes and Tips

Verify the vehicle is a 2010-2016 Hyundai Genesis Coupe with front Mando Brakes 1-piston calipers before ordering. Confirm rotor dimensions, bolt pattern, and hub interface against the existing part and brake system specifications. Clean the hub mounting surface before installation and inspect pads, calipers, and hardware condition during brake service.

Quality Assurance

Use the listed dimensions and application details to confirm fitment before installation. The DFC Brake Rotor 600-03034 is identified for the specified front brake application on the Hyundai Genesis Coupe.