Dynamite Friction 600-11001 Disc Brake Rotor - Front

DFC Brake Rotor for Land Rover Front Fitment

The Dynamite Friction DFC Brake Rotor, part number 600-11001, is a vented front disc brake rotor built for specific Land Rover applications. It matches the listed dimensions for a direct-fit replacement on select Defender and Range Rover models, including Land Rover Defender and Land Rover Range Rover front brake service.

Key Features

• Part number: 600-11001
• DFC Brake Rotor product line from Dynamite Friction
• Vented disc brake rotor construction
• Outside diameter: 299 mm
• Inside diameter: 101.6 mm
• Height: 70 mm
• Nominal thickness: 24 mm
• Discard thickness: 22 mm
• 5-bolt hole design with 10 mm bolt hole diameter

Detailed Description

This DFC Brake Rotor is engineered to the listed OE-style dimensions for front brake applications on Land Rover Defender, Defender 90, and Range Rover models. The vented rotor design supports front axle brake service where heat management and consistent braking performance are important. With a 299 mm outside diameter, 24 mm nominal thickness, and 22 mm discard thickness, part number 600-11001 is specified for vehicles that require these exact measurements.

The DFC Brake Rotor line focuses on application-specific fitment and dimensional accuracy. For buyers searching for a front brake rotor for 2011-2016 Land Rover Defender, a front rotor for 1994-1995 Land Rover Defender 90, or a front brake rotor for 1990-1995 Land Rover Range Rover, this part number provides a direct reference point for matching the correct rotor to the vehicle.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Front brake rotor wear that requires replacement
• Brake pulsation caused by rotor thickness loss or uneven wear
• Reduced braking consistency from a worn vented rotor
• Service needs on Land Rover Defender and Range Rover front brake systems
• Rotor replacement when exact diameter, height, and bolt pattern matter

Installation Notes and Tips

Verify rotor dimensions, bolt hole quantity, bolt hole diameter, and hub fitment before installation. Confirm that the vehicle uses a front vented rotor with the listed 299 mm outside diameter and 70 mm height. Always inspect pads, calipers, and hub surfaces during brake service, and replace worn components as needed to maintain proper braking contact.

Quality Assurance

DFC Brake Rotor parts are built around application-specific measurements for accurate fitment on the listed Land Rover vehicles. Part number 600-11001 is matched to the documented front applications for Defender, Defender 90, and Range Rover models.