Dynamite Friction 600-13028 Disc Brake Rotor - Rear

Rear Vented Brake Rotor for Subaru Applications

The Dynamite Friction DFC Brake Rotor, part number 600-13028, is a rear disc brake rotor built for Subaru vehicles that call for a vented rotor design. With a 300 mm outside diameter, 46.5 mm height, 5-bolt pattern, and 13 mm bolt hole diameter, it matches the dimensional requirements needed for proper rear brake service on select Subaru Forester, Legacy, Outback, and WRX applications.

Use this DFC Brake Rotor when replacing a worn rear rotor on Subaru models with the specified fitment. The 600-13028 is sized for direct rear brake maintenance on vehicles equipped with standard rear braking setups and, on WRX applications, electric parking brake or EyeSight-related configurations noted in the fitment data.

Key Features

• Brand: Dynamite Friction
• Brand line: DFC Brake Rotor
• Part number: 600-13028
• Rear disc brake rotor for Subaru fitments
• Vented rotor construction for rear brake service
• Outside diameter: 300 mm
• Nominal thickness: 17 mm
• Discard thickness: 15 mm
• Height: 46.5 mm
• 5-bolt hole pattern with 13 mm bolt hole diameter
• Inside diameter: 58 mm

DFC Brake Rotor Line Details

The DFC Brake Rotor line focuses on replacement rotors built around application-specific dimensions. For Subaru rear brake service, the 600-13028 follows the measured rotor specifications needed for proper fitment, including thickness, diameter, height, and bolt pattern details that matter during brake repair and rotor replacement.

Fitment

• Fits 2025-2026 Subaru Forester, rear.
• Fits 2015-2025 Subaru Legacy, rear.
• Fits 2015-2025 Subaru Outback, rear.
• Fits 2022-2025 Subaru WRX, rear, Electric Parking Brake.
• Fits 2020-2021 Subaru WRX, rear, EyeSight Technology (Electric Parking Brake).
• Fits 2016-2019 Subaru WRX, rear, with EyeSight Technology (Electric Parking Brake).

What This Rotor Helps Address

• Rear brake pulsation caused by rotor wear or thickness variation
• Brake noise related to worn or uneven rear rotors
• Reduced braking consistency from heat-worn rotor surfaces
• Service needs on Subaru rear brake systems with vented rotor specifications
• Replacement of rotors that have reached discard thickness

Installation Notes and Tips

Confirm rotor dimensions against the vehicle’s rear brake specification before installation. On Subaru WRX models with Electric Parking Brake or EyeSight Technology, verify the rear brake configuration and rotor match before service. Inspect pads, caliper condition, and hub surfaces during rotor replacement to help ensure even contact and proper brake operation.

Quality Assurance

Dynamite Friction supplies the DFC Brake Rotor as an application-specific replacement part for confirmed Subaru rear fitments. Part number 600-13028 is built to the listed dimensional requirements for the vehicles shown above.