Dynamite Friction 600-23003 Disc Brake Rotor - Front

DFC Brake Rotor Overview

The Dynamite Friction DFC Brake Rotor 600-23003 is a solid disc brake rotor built for precise brake service where OE-style dimensions matter. With a 238 mm outside diameter, 41.1 mm height, and 4-bolt mounting pattern, it is suited for applications that call for a compact solid rotor design.

For shoppers searching for a brake rotor for Honda Civic or similar compact vehicle brake service, this DFC Brake Rotor line focuses on consistent fitment dimensions and straightforward replacement sizing. Part number 600-23003 is identified by its solid rotor construction and measured thickness specifications.

Key Features

• Part number: 600-23003
• DFC Brake Rotor from Dynamite Friction
• Solid disc brake rotor design
• Outside diameter: 238 mm
• Height: 41.1 mm
• Nominal thickness: 12 mm
• Discard thickness: 11 mm
• Bolt hole quantity: 4
• Bolt hole diameter: 15 mm
• Inside diameter: 61 mm

Detailed Description

The 600-23003 rotor is engineered around the listed dimensional specs, including a 12 mm nominal thickness and 11 mm discard thickness, which are important reference points during brake inspection and replacement. Its solid rotor construction makes it a direct-fit style component for vehicles that use a non-vented front or rear rotor design, depending on the application. If you are comparing brake rotor dimensions for Honda Civic brake repair or other compact car brake service, this part number provides the measurements needed for accurate matching.

The DFC Brake Rotor product line is positioned as a straightforward brake service solution within Dynamite Friction’s catalog, with this rotor focused on dimensional accuracy rather than added features. Part number 600-23003 should be matched carefully to the vehicle’s original rotor size, bolt pattern, and hub dimensions before installation.

What This Rotor Helps Address

• Brake pulsation caused by a worn rotor surface
• Reduced braking performance from rotor wear beyond discard thickness
• Rotor replacement needs during routine brake service
• Fitment issues when the bolt pattern or diameter does not match OE dimensions
• Noise or uneven braking linked to an out-of-spec rotor

Installation Notes and Tips

Verify the rotor’s outside diameter, height, bolt hole quantity, and center dimensions against the original part before installation. Measure the existing rotor to confirm it is at or below the discard thickness threshold of 11 mm before replacing it with 600-23003. Clean the hub mounting surface thoroughly and inspect pads, caliper condition, and wheel hardware during brake service. For Honda Civic brake rotor replacement searches and other vehicle-specific brake jobs, confirm the exact application by year, make, model, and position before ordering.

Quality Assurance

Quality control should begin with dimensional verification against the vehicle’s original brake rotor specifications. The DFC Brake Rotor 600-23003 is defined by its published measurements, allowing technicians and buyers to confirm fitment before service. No warranty information was provided in the product data.