Dynamite Friction 600-40088 Disc Brake Rotor - Front

Dynamite Friction DFC Brake Rotor for Ram Front Brakes

The Dynamite Friction DFC Brake Rotor, part number 600-40088, is a vented front disc brake rotor built for 2000-2002 Dodge Ram 2500 and 2000-2002 Dodge Ram 3500 applications. With an outside diameter of 326.5 mm and an 8-bolt pattern, it matches the dimensional requirements for these heavy-duty front brake setups.

The DFC Brake Rotor line focuses on application-specific rotor fitment and consistent braking geometry. This rotor uses a vented design to support heat dissipation in front brake service, while the 35.5 mm nominal thickness and 33.53 mm discard thickness provide the key wear dimensions needed for replacement planning.

Key Features

• Part number 600-40088 from Dynamite Friction
• Front disc brake rotor for Dodge Ram 2500 and Dodge Ram 3500
• Vented rotor construction for front axle brake service
• 326.5 mm outside diameter with 102 mm height
• 8 bolt holes with 16.9 mm bolt hole diameter
• 122.3 mm inside diameter for application-specific hub fitment
• Nominal thickness: 35.5 mm
• Discard thickness: 33.53 mm

Detailed Description

Built for front brake replacement on 2000-2002 Dodge Ram 2500 and 2000-2002 Dodge Ram 3500 models, this DFC Brake Rotor is sized to match the original brake package dimensions. The vented rotor design supports front axle braking demands, while the measured thickness and diameter specifications help ensure the rotor aligns with the vehicle’s brake hardware and service limits. If you are searching for a front brake rotor for Dodge Ram 2500 or Dodge Ram 3500, part number 600-40088 provides the correct fitment profile for these model years.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Is Used For

• Replacing a worn front brake rotor on a 2000-2002 Dodge Ram 2500
• Replacing a worn front brake rotor on a 2000-2002 Dodge Ram 3500
• Addressing brake pulsation caused by rotor wear or thickness variation
• Restoring proper front brake contact surface after scoring or heat damage
• Supporting consistent braking performance during routine brake service

Installation Notes and Tips

Verify rotor dimensions, bolt pattern, and hub fitment before installation. Clean the hub mounting surface thoroughly and inspect pads, calipers, and wheel bearings during brake service. Always confirm the rotor meets the vehicle’s discard thickness requirement before reuse or replacement decisions.

Quality Assurance

Dynamite Friction DFC Brake Rotor 600-40088 is built to the listed dimensional specifications for the confirmed Dodge Ram 2500 and Dodge Ram 3500 front brake applications.