Dynamite Friction 600-42015 Disc Brake Rotor - Front

DFC Brake Rotor for Jeep Front Applications

The Dynamite Friction DFC Brake Rotor, part number 600-42015, is a vented front disc brake rotor built for select Jeep Cherokee, Comanche, Wagoneer, and Wrangler applications from 1984-1989. With a 280 mm outside diameter and 22.2 mm nominal thickness, it matches the dimensional requirements needed for proper brake service on the listed vehicles.

The DFC Brake Rotor line focuses on direct-fit brake replacement parts for common service jobs. This rotor is specified for front axle use and is listed across multiple Jeep platforms, including Jeep Cherokee and Jeep Wrangler front brake applications.

Key Features

• Part number 600-42015 DFC Brake Rotor
• Vented disc brake rotor construction for front brake service
• 280 mm outside diameter
• 22.2 mm nominal thickness and 20.7 mm discard thickness
• 5-bolt hole design with 15.7 mm bolt hole diameter
• 72 mm inside diameter and 76.7 mm height
• Compatible with select 1984-1989 Jeep Cherokee, Comanche, Wagoneer, and Wrangler front applications

Detailed Description

Built as a front disc brake rotor for Jeep brake repair, this Dynamite Friction rotor is dimensioned for the listed Cherokee, Comanche, Wagoneer, and Wrangler fitments. The vented design helps support heat dissipation during repeated braking, while the listed thickness and diameter specifications provide the measurements needed for correct rotor matching during brake service. If you are replacing worn front rotors on a 1984-1989 Jeep Cherokee, 1988-1989 Jeep Comanche, 1986-1989 Jeep Wagoneer, or 1987-1989 Jeep Wrangler, part number 600-42015 is the direct reference to verify against your existing rotor dimensions.

What It Helps Fix

• Brake pulsation caused by rotor wear or thickness variation
• Scoring, grooves, or heat checking on the front rotor surface
• Reduced braking consistency during stop-and-go driving
• Rotor replacement needs during front brake service on Jeep Cherokee, Comanche, Wagoneer, or Wrangler models

Installation Notes and Tips

Confirm rotor diameter, bolt pattern, and hub dimensions before installation. This rotor is listed for front position use only, so match it to the vehicle’s front brake setup and verify the rear axle and shoe configuration noted in the fitment data where applicable. For best results, inspect pads, calipers, and hub surfaces during service and clean all mating surfaces before installing the new rotor.

Quality Assurance

Use the published dimensions and vehicle fitment data to confirm application before purchase. The DFC Brake Rotor line is positioned as a direct replacement brake component for service work on the listed Jeep models, and part number 600-42015 should be matched to the vehicle’s front brake specifications.