Dynamite Friction 600-63162 Disc Brake Rotor - Rear

Rear Vented Brake Rotor for Mercedes-Benz SUVs and AMG Models

The Dynamite Friction DFC Brake Rotor 600-63162 is a rear disc brake rotor built for select Mercedes-Benz applications that use a vented rotor design. With a 320 mm outside diameter, 24 mm nominal thickness, and 21.4 mm discard thickness, it matches the dimensional requirements needed for proper rear brake service on covered vehicles.

The DFC Brake Rotor line focuses on direct-fit replacement rotors for everyday repair and maintenance. This rotor is engineered around the original fitment profile for rear brake service on Mercedes-Benz C43 AMG, GLC43 AMG, GLC300, GLC350e, GLC250, and C450 AMG applications listed below.

• Part number: 600-63162
• Rear disc brake rotor for select Mercedes-Benz models
• Vented rotor construction for rear brake applications
• 320 mm outside diameter with 48.8 mm height
• 5-bolt hole design with 15.4 mm bolt hole diameter
• 69 mm inside diameter for fitment-specific hub alignment
• Nominal thickness: 24 mm; discard thickness: 21.4 mm

Fitment Details

• Fits 2017-2023 Mercedes-Benz C43 AMG, rear.
• Fits 2023 Mercedes-Benz GLC300, rear, 342mm front disc.
• Fits 2017-2023 Mercedes-Benz GLC43 AMG, rear.
• Fits 2022 Mercedes-Benz GLC300, rear.
• Fits 2016-2021 Mercedes-Benz GLC300, rear, fits vehicles without Sport Package.
• Fits 2016-2021 Mercedes-Benz GLC300, rear, Sport Package.
• Fits 2018-2020 Mercedes-Benz GLC350e, rear.
• Fits 2017-2018 Mercedes-Benz GLC250, rear, Sport Package.
• Fits 2017-2018 Mercedes-Benz GLC250, rear, fits vehicles without Sport Package.
• Fits 2016 Mercedes-Benz C450 AMG, rear.

What This Rotor Helps Address

• Rear brake pulsation caused by rotor wear or thickness variation
• Reduced braking performance from a worn rear rotor surface
• Noise from a rotor that has reached discard thickness
• Service replacement for rear brake maintenance on Mercedes-Benz GLC and AMG models
• Fitment-specific replacement when the original rear rotor is no longer serviceable

Installation Notes and Tips

Verify rear axle fitment by model, year, and package details before installation. This rotor is listed for specific Mercedes-Benz GLC300 applications with and without Sport Package, so confirm the vehicle configuration against the fitment table. Measure the existing rotor and compare outside diameter, thickness, and hub dimensions before completing brake service.

For best results, inspect pads, caliper hardware, and wheel hub condition during rotor replacement. Clean the hub mounting surface thoroughly so the rotor seats flat and the brake system can operate as intended.

Quality Assurance

The DFC Brake Rotor 600-63162 is built as a direct replacement rotor for covered Mercedes-Benz rear brake applications, with dimensions listed to support accurate fitment and service consistency.