Dynamite Friction 600-67038 Disc Brake Rotor - Rear

Rear Disc Brake Rotor for Nissan Sentra and NX

The Dynamite Friction DFC Brake Rotor, part number 600-67038, is a solid rear disc brake rotor built for specific Nissan applications. It is engineered with the correct dimensions for 1991-1994 Nissan Sentra rear and 1991-1993 Nissan NX rear fitment, including Made in Japan vehicles.

Key Features

• Brand: Dynamite Friction
• Brand line: DFC Brake Rotor
• Part number: 600-67038
• Solid rotor design for rear brake service
• Outside diameter: 258 mm
• Height: 44.5 mm
• Nominal thickness: 9 mm
• Discard thickness: 8 mm
• Inside diameter: 68.1 mm
• Bolt hole quantity: 4
• Bolt hole diameter: 12.75 mm

DFC Brake Rotor Details

The DFC Brake Rotor line from Dynamite Friction focuses on direct-fit brake rotor replacement for vehicles that need accurate dimensions and consistent braking surface geometry. This 600-67038 rotor uses a solid construction and the listed hub and bolt pattern measurements to match the rear brake setup on select Nissan Sentra and Nissan NX models.

Vehicle Fitment

• Fits 1991-1994 Nissan Sentra, rear. Made in Japan; DFC Brake Rotor.
• Fits 1991-1993 Nissan NX, rear. Made in Japan; DFC Brake Rotor.

Common Issues This Rotor Can Address

• Rear brake pulsation from a worn or uneven rotor surface
• Brake noise caused by rotor wear beyond discard thickness
• Reduced braking consistency from rotor thickness variation
• Corrosion or scoring on the rear brake rotor face
• Service replacement needs for Nissan Sentra and Nissan NX rear brakes

Installation Notes and Tips

Verify rear axle application, rotor dimensions, and bolt pattern before installation. Measure the existing rotor against the discard thickness of 8 mm and confirm the hub and mounting dimensions match the vehicle. For best results, inspect pads, caliper hardware, and wheel bearing condition during brake service on the Nissan Sentra or Nissan NX.

Quality Assurance

Use this rotor as a direct replacement for the listed rear applications when the vehicle matches the fitment data and dimensional requirements. The DFC Brake Rotor line is built around application-specific sizing for accurate brake service on supported Nissan models.