Dynamite Friction 600-72055 Disc Brake Rotor - Front

Front Vented Brake Rotor for Montero Sport

The Dynamite Friction DFC Brake Rotor 600-72055 is a front disc brake rotor built for 2000-2004 Mitsubishi Montero Sport applications with 315mm front rotors. It uses a vented rotor design to support heat management during repeated braking and everyday driving.

Key Features

• Part number: 600-72055
• Brand line: DFC Brake Rotor
• Front disc brake rotor for Mitsubishi Montero Sport fitment
• Vented rotor construction
• Outside diameter: 314 mm
• Nominal thickness: 24.1 mm
• Discard thickness: 22.4 mm
• Height: 45.3 mm
• 6-bolt hole pattern with 10.5 mm bolt hole diameter
• Inside diameter: 87 mm

Product Details

The DFC Brake Rotor line from Dynamite Friction focuses on direct-fit brake rotor replacement for vehicles that require accurate dimensions and consistent braking surface geometry. This 600-72055 rotor is specified for the front axle on 2000-2004 Mitsubishi Montero Sport models and matches the listed 315mm front rotor application. The vented design helps move air through the rotor body, while the measured thickness and diameter specifications support proper fitment and service replacement planning.

Part number 600-72055 is a practical choice when replacing worn front rotors on a Mitsubishi Montero Sport and when maintaining OE-style brake dimensions matters. The rotor’s 6-bolt pattern, 314 mm outside diameter, and 45.3 mm height provide the dimensional details needed for accurate ordering and installation verification.

Common Brake Issues This Rotor Can Address

• Brake pulsation caused by rotor wear or thickness variation
• Reduced braking performance from worn front rotors
• Noise related to uneven rotor surfaces
• Service replacement for rotors at or near discard thickness
• Front brake maintenance on 2000-2004 Mitsubishi Montero Sport models

Installation Notes and Tips

Fits 2000-2004 Mitsubishi Montero Sport, front. Confirm the vehicle’s 315mm front rotor specification before ordering, and compare the rotor’s outside diameter, bolt hole quantity, bolt hole diameter, and height to the removed part. Clean the hub mounting surface before installation to help prevent runout-related brake noise or pedal vibration. Always inspect pads, caliper condition, and hardware wear during rotor replacement.

Quality Assurance

Dynamite Friction brake components are built around application-specific dimensions for direct replacement use. This rotor is identified by part number 600-72055 and the DFC Brake Rotor line designation for straightforward catalog matching and fitment verification.