Dynamite Friction 600-73014 Disc Brake Rotor - Front

Front Vented Brake Rotor for Audi Applications

The Dynamite Friction DFC Brake Rotor 600-73014 is a front disc brake rotor built for select Audi performance and luxury models. It features a vented design with a 276 mm outside diameter, 25 mm nominal thickness, and 23 mm discard thickness for direct-fit front brake service.

Compatible With 1990-1994 Audi V8 Quattro front brakes with Girling front brakes, 1992-1994 Audi S4 front, and 1995-1997 Audi S6 front. The DFC Brake Rotor line focuses on application-specific rotor dimensions for straightforward replacement fitment.

Key Features

• Part number 600-73014 front disc brake rotor
• Vented rotor construction for front axle brake applications
• 276 mm outside diameter
• 25 mm nominal thickness and 23 mm discard thickness
• 5-bolt hole pattern with 15.5 mm bolt hole diameter
• 68 mm inside diameter and 59.5 mm height
• Fits select Audi S4, Audi S6, and Audi V8 Quattro front brake setups

Detailed Description

Dynamite Friction 600-73014 is a vented front brake rotor engineered around the listed Audi fitments and brake dimensions. The rotor’s 276 mm outside diameter, 5-bolt pattern, and specified thickness measurements support accurate replacement on vehicles that use the matching front brake configuration. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Use this rotor when servicing front brake systems on 1995-1997 Audi S6, 1992-1994 Audi S4, and 1990-1994 Audi V8 Quattro models equipped with Girling front brakes. The part number 600-73014 is the reference to verify against your existing rotor and vehicle brake setup before ordering.

Common Issues This Rotor Can Address

• Front brake pulsation caused by rotor wear or thickness variation
• Reduced braking consistency from a worn vented rotor
• Rotor replacement needs during front brake service
• Fitment matching for Audi S4, Audi S6, and V8 Quattro front brake systems
• Brake noise or vibration related to an out-of-spec rotor

Installation Notes and Tips

Confirm rotor dimensions, bolt pattern, and front brake configuration before installation. For 1990-1994 Audi V8 Quattro applications, verify Girling front brakes specifically, since that note is part of the confirmed fitment. Inspect pads, calipers, and hub surfaces during service so the new rotor seats correctly.

Use the vehicle’s existing brake specifications and the part number 600-73014 to confirm the correct front rotor before installation on Audi S4, Audi S6, or V8 Quattro models.

Quality Assurance

The DFC Brake Rotor line is built around defined application data and published rotor measurements for accurate replacement selection. Verify all fitment details against your vehicle before purchase to ensure the correct front brake rotor is selected.