Dynamite Friction 600-76081 Disc Brake Rotor - Front

Front Vented Brake Rotor for Toyota Corolla

The Dynamite Friction DFC Brake Rotor 600-76081 is a front disc brake rotor built for select Toyota, Scion, and Pontiac applications. It uses a vented rotor design with a 275 mm outside diameter, 22 mm nominal thickness, and 19 mm discard thickness for direct replacement service on listed vehicles.

Key Features

• Part number: 600-76081
• DFC Brake Rotor line from Dynamite Friction
• Front disc brake rotor application
• Vented rotor construction for front axle use
• Outside diameter: 275 mm
• Nominal thickness: 22 mm
• Discard thickness: 19 mm
• Height: 46.6 mm
• Inside diameter: 55 mm
• Bolt hole quantity: 5
• Bolt hole diameter: 14.5 mm

Product Details

The DFC Brake Rotor line focuses on replacement rotors with application-specific dimensions for proper fitment and braking surface alignment. This 600-76081 rotor is specified for front use on 2009-2019 Toyota Corolla, 2008-2014 Scion xD, 2009-2013 Toyota Matrix, and 2009-2010 Pontiac Vibe. If you are searching for a front brake rotor for Toyota Corolla 2009-2019 or a front rotor for Scion xD 2008-2014, this part number matches the listed vehicle coverage.

Use this rotor when replacing a worn or below-spec front brake disc on the supported Corolla, Matrix, xD, or Vibe applications. The vented design supports front axle braking demands, while the listed thickness and diameter measurements help confirm correct rotor selection before installation. Part number 600-76081 is also a useful reference when comparing front brake rotor options for Toyota Matrix and Pontiac Vibe applications.

What It Helps Address

• Brake pulsation from a worn or uneven rotor surface
• Reduced braking performance from rotor wear below discard thickness
• Noise caused by rotor surface damage or heat checking
• Front brake service needs on Corolla, Matrix, xD, and Vibe models
• Rotor replacement after inspection shows thickness outside specification

Installation Notes and Tips

Confirm vehicle year, make, model, and front position before ordering. Verify rotor dimensions against the existing part, including outside diameter, height, bolt hole quantity, and bolt hole diameter. Inspect pads, calipers, and hub surfaces during brake service so the new rotor seats correctly and the braking system returns to proper operation. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Quality Assurance

Manufactured under the Dynamite Friction DFC Brake Rotor product line, this rotor is built to match the listed application dimensions for direct replacement use on confirmed fitments.