Dynamite Friction 604-58019 Disc Brake Rotor - Rear

Rear Disc Brake Rotor for Honda Element and Acura TL

The Dynamite Friction DFC GEOSPEC Coated Rotor, part number 604-58019, is a solid rear disc brake rotor built for specific Honda and Acura applications. It is engineered with a coated surface to help resist corrosion on exposed rotor areas while maintaining the braking surface needed for consistent rear brake service.

Key Features

• DFC GEOSPEC coated rotor from Dynamite Friction
• Part number 604-58019 for rear brake applications
• Solid rotor design
• Outside diameter: 282 mm
• Nominal thickness: 9 mm
• Discard thickness: 7.5 mm
• Height: 58.7 mm
• 5-bolt hole pattern with 12.45 mm bolt hole diameter
• Inside diameter: 64.2 mm

Product Details

The DFC GEOSPEC Coated Rotor line focuses on corrosion protection for the non-friction surfaces of the rotor while preserving the braking face for normal rear brake operation. This rotor measures 282 mm outside diameter, 9 mm nominal thickness, and 7.5 mm discard thickness, making it a direct-spec replacement for vehicles that use a solid rear rotor. The 5-bolt pattern, 64.2 mm inside diameter, and 58.7 mm height support proper fitment on the listed Honda Element and Acura TL rear brake applications. Part number 604-58019 is a practical choice when replacing a worn or rusted rear rotor on these platforms.

Compatible With 2003-2011 Honda Element, rear. Compatible With 1999-2008 Acura TL, rear. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Reasons for Replacement

• Rear rotor wear below service limits
• Brake pulsation caused by rotor thickness variation
• Surface rust on the rotor hat or non-friction areas
• Noise from uneven or damaged rotor surfaces
• Reduced braking consistency during rear brake service

Installation Notes and Tips

Verify rotor dimensions and rear axle fitment before installation. Clean the hub mounting surface thoroughly to help prevent runout issues, and inspect rear pads, caliper hardware, and parking brake components at the same time. After installation, follow the vehicle manufacturer’s brake bedding procedure for proper pad and rotor seating.

Quality Assurance

Built as a coated replacement rotor for specified Honda and Acura rear brake applications, this Dynamite Friction rotor is intended to meet the dimensional requirements listed above. Confirm part number 604-58019 against your vehicle’s rear brake specifications before ordering.