Dynamite Friction 631-03065L Disc Brake Rotor - Rear Left

Dynamite Friction DFC Rear Left Rotor for Veloster N

The Dynamite Friction DFC Brake Rotor - Drilled and Slotted - Silver is a rear left disc brake rotor built for 2019-2022 Hyundai Veloster N models with the Standard Package and red calipers without the N logo. Part number 631-03065L combines a slotted X drilled surface with a zinc silver hat finish and rust resistant coating for a clean, service-ready replacement.

Key Features

• Fits 2019-2022 Hyundai Veloster N, rear left
• Part number 631-03065L
• Slotted X drilled brake surface for directional braking performance
• 300 mm outside diameter with 12 mm nominal thickness and 10 mm discard thickness
• Solid rotor design with plain disc finish
• Zinc silver hat finish and rust resistant coating
• 5-bolt pattern with 114.3 mm bolt circle diameter
• 76 mm center hole diameter and 12.5 mm bolt hole diameter

Product Details

This DFC rotor is part of Dynamite Friction’s drilled and slotted silver rotor line, which focuses on direct-fit brake service with corrosion protection and a performance-oriented surface design. The directional slotted X drilled face helps maintain consistent pad contact, while the silver zinc hat finish supports a cleaner appearance behind the wheel. If you are replacing the rear left rotor on a Hyundai Veloster N, part number 631-03065L matches the listed application and dimensions for a precise service replacement.

Common Problems This Rotor Addresses

• Brake pulsation from a worn or uneven rotor surface
• Reduced braking consistency caused by heat buildup
• Surface rust on exposed rotor components
• Noise or vibration from rotor wear
• Need for a direct replacement on the rear left side of a Veloster N

Installation Notes and Tips

Verify rotor dimensions, bolt pattern, and position before installation. This rotor is listed for the rear left position on 2019-2022 Hyundai Veloster N Standard Package models with red calipers without the N logo and a 330 mm front disc. Clean the hub mounting surface before installing the new rotor, and inspect pads and caliper hardware for wear at the same time. Confirm that the directional surface is oriented correctly during installation.

Quality Assurance

Part number 631-03065L is built to the published specifications for outside diameter, thickness, bolt circle, and center hole dimensions. It is finished with a rust resistant coating and zinc silver hat coating for added corrosion protection in brake service applications.