Dynamite Friction 631-76089R Disc Brake Rotor - Rear Right

Drilled and Slotted Rear Rotor for Toyota Fitment

The Dynamite Friction DFC Brake Rotor - Drilled and Slotted - Silver, part number 631-76089R, is a rear right disc brake rotor built for specific Toyota applications. It combines a slotted X drilled surface with a zinc silver hat finish and rust resistant coating for a clean, service-ready appearance.

Compatible With 2016-2020 Toyota Mirai, rear right, and 2012-2017 Toyota Prius V, rear right. The directional brake surface and solid rotor design support consistent rear braking performance for these vehicle-specific applications.

Key Features

• Part number 631-76089R
• Drilled and slotted rotor surface with directional braking face
• Zinc silver hat finish with rust resistant coating
• Solid rotor construction
• Outside diameter: 290 mm
• Nominal thickness: 12 mm; discard thickness: 10.5 mm
• 5-bolt, 5-lug pattern with 114 mm bolt circle diameter
• Center hole diameter: 62.1 mm

Product Details

The DFC Brake Rotor - Drilled and Slotted - Silver line focuses on application-specific brake rotors with a finished appearance and corrosion protection. This rotor uses a plain disc finish with a zinc silver hat finish, plus a rust resistant coating to help maintain surface condition during normal service. For Toyota Mirai and Toyota Prius V rear right fitments, 631-76089R matches the listed dimensions and mounting pattern for direct replacement use.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What This Rotor Helps Address

• Rear brake pulsation caused by worn rotor surfaces
• Uneven braking feel from heat-affected rotor faces
• Corrosion on exposed rotor and hat surfaces
• Noise associated with worn or scored rear rotors
• Fitment issues when replacing the rear right rotor on listed Toyota models

Installation Notes and Tips

Verify rear right position, bolt circle diameter, center hole diameter, and rotor height before installation. Clean the hub mounting surface and inspect pads, caliper hardware, and wheel bearings for wear before installing the new rotor. Because this rotor uses a directional brake surface, confirm correct orientation during installation on the vehicle.

Quality Assurance

Dynamite Friction supplies this rotor as a vehicle-specific brake component with corrosion-resistant finishing and dimensional specifications listed for the confirmed Toyota applications. Review all measurements and fitment details against the vehicle before service.