Dynamite Friction 633-03017L Disc Brake Rotor - Rear Left

Rear Left Drilled and Slotted Rotor for Tiburon

The Dynamite Friction DFC Brake Rotor - Drilled and Slotted - Black, part number 633-03017L, is a rear left disc brake rotor for select Hyundai Tiburon applications. It combines a directional slotted and drilled surface with a black zinc hat finish and rust-resistant coating for a clean, service-ready appearance.

Key Features

• Fits 2003-2008 Hyundai Tiburon, rear left
• Part number 633-03017L for application-specific lookup
• Slotted X drilled braking surface for consistent pad contact
• Directional rotor surface for correct rotation-specific installation
• Solid rotor design with 258 mm outside diameter
• Nominal thickness: 10 mm; discard thickness: 8 mm
• 5-lug pattern with 114.3 mm bolt circle and 76 mm center hole
• Zinc black hat finish with rust-resistant coating

Product Details

This DFC Brake Rotor - Drilled and Slotted - Black is built for the rear left position on the 2003-2008 Hyundai Tiburon. The rotor uses a plain disc finish with a slotted X drilled surface and directional braking pattern, helping maintain stable pad-to-rotor contact under repeated braking. The black zinc hat finish and rust-resistant coating support long-term appearance and corrosion protection in normal service conditions. If you are searching for a 2003-2008 Hyundai Tiburon rear left brake rotor, part number 633-03017L identifies the correct application.

For buyers comparing Hyundai Tiburon brake rotor options, 633-03017L provides the fitment-specific dimensions needed for the rear left side, including 5 bolt holes, 5 stud/lug holes, and a 114.3 mm bolt circle. This rotor is a direct match for the listed vehicle applications and position.

Common Problems This Rotor Can Address

• Brake pulsation from a worn rear rotor surface
• Reduced braking consistency from heat-affected rotor faces
• Corrosion on the rotor hat or exposed metal surfaces
• Uneven pad contact on a damaged rear left rotor
• Noise or vibration caused by rotor wear beyond discard thickness

Installation Notes and Tips

Verify rear left fitment before installation and confirm the rotor matches the vehicle’s 114.3 mm bolt circle, 76 mm center hole, and 258 mm outside diameter. Because this rotor is directional, install it in the correct rotation orientation for the rear left side of the Hyundai Tiburon. Inspect pads, caliper condition, and hub surface before service to help ensure proper rotor seating and braking performance.

Quality Assurance

Dynamite Friction supplies this rotor as a fitment-specific brake component for the listed Hyundai Tiburon applications. Part number 633-03017L is identified for 2003-2008 Hyundai Tiburon rear left use, making it easier to confirm the correct replacement during brake service.