Dynamite Friction 633-47011R Disc Brake Rotor - Front Right

Drilled and Slotted Front Right Rotor

The Dynamite Friction DFC Brake Rotor - Drilled and Slotted - Black, part number 633-47011R, is a vented disc brake rotor built for the front right position on select Chevrolet Corvette applications. It combines a slotted X drilled surface with a zinc black hat finish and rust resistant coating for a clean, service-ready appearance.

For drivers searching for a front right brake rotor for 1963-1982 Chevrolet Corvette disc brake setups, this rotor is built around the listed dimensions and directional braking surface requirements. The 633-47011R is also a direct fit for 1967-1982 Chevrolet Corvette front right applications.

Key Features

• Brand: Dynamite Friction
• Brand line: DFC Brake Rotor - Drilled and Slotted - Black
• Part number: 633-47011R
• Vented disc brake rotor with slotted X drilled surface
• Directional brake surface for the specified front right position
• Outside diameter: 298 mm
• Nominal thickness: 31.75 mm
• Discard thickness: 30.86 mm
• Center hole diameter: 71.5 mm
• 5-bolt pattern with 120.7 mm bolt circle diameter
• Zinc black hat finish with rust resistant coating

DFC Brake Rotor Line Details

The DFC Brake Rotor - Drilled and Slotted - Black line focuses on rotor construction details that matter during brake service, including vented design, directional surface geometry, and corrosion protection. On this Chevrolet Corvette rotor, the black hat finish and coated surface help maintain a cleaner appearance while supporting consistent brake system maintenance.

Detailed Description

The Dynamite Friction 633-47011R is a drilled and slotted front right disc brake rotor engineered for Chevrolet Corvette fitments from 1963-1982, with the 1963-1966 models listed for disc brake applications and 1967-1982 models listed for the same front right position. Its 298 mm outside diameter, 31.75 mm nominal thickness, and 78.2 mm overall height align with the specified brake package dimensions, while the 5-lug, 120.7 mm bolt circle and 71.5 mm center hole support proper hub fitment. The directional slotted and drilled braking surface is intended for vehicles that require this rotor configuration, and the vented design supports heat management during repeated braking.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What This Rotor Helps Address

• Brake rotor wear that requires replacement at the front right corner
• Surface corrosion on an exposed brake rotor
• Brake pulsation related to rotor condition
• Heat buildup during repeated braking events
• Fitment needs for a Chevrolet Corvette disc brake rotor with the listed dimensions

Installation Notes and Tips

Verify rotor diameter, center hole diameter, bolt circle diameter, and thickness before installation. This rotor is listed for the front right position only, so confirm side and application details against the vehicle’s brake setup before service. Clean the hub mounting surface thoroughly and inspect pads, caliper condition, and wheel clearance during brake work.

Quality Assurance

Built by Dynamite Friction for the specified Corvette applications, this rotor uses a rust resistant coating and zinc black hat finish to support corrosion resistance in service. Confirm all measurements and fitment details against the vehicle before installation.