Dynamite Friction 633-67049L Disc Brake Rotor - Front Left

Drilled and Slotted Front Left Rotor

The Dynamite Friction DFC Brake Rotor - Drilled and Slotted - Black, part number 633-67049L, is a front left disc brake rotor built for specific Nissan and INFINITI applications. It features a vented design, directional slotted X drilled surface, and a zinc black hat finish with rust-resistant coating for added corrosion protection.

• Part number: 633-67049L
• Front left disc brake rotor
• Vented rotor construction
• Directional slotted X drilled braking surface
• Plain disc finish with zinc black hat finish
• Rust resistant coating: yes
• 5-bolt, 5-lug pattern
• Bolt circle diameter: 114.3 mm
• Outside diameter: 296 mm
• Nominal thickness: 24 mm
• Discard thickness: 22 mm
• Center hole diameter: 68 mm

DFC Brake Rotor Line Details

The DFC Brake Rotor - Drilled and Slotted - Black line focuses on rotor fitment, braking surface design, and corrosion resistance. This rotor uses a directional slotted X drilled surface to support consistent pad contact and heat management in the front braking position, while the black hat finish helps maintain a cleaner appearance behind the wheel.

Fits 2002-2006 Nissan Altima, front left. Fits 2002-2004 INFINITI I35, front left. Fits 2002-2003 Nissan Maxima, front left. This part number 633-67049L is also a direct reference point when verifying the correct front left rotor for these applications.

What This Rotor Helps Address

• Front brake rotor wear on the listed Nissan and INFINITI vehicles
• Brake pulsation caused by a worn or uneven rotor surface
• Corrosion on exposed rotor and hat surfaces
• Reduced braking consistency from heat-affected rotor surfaces
• Replacement needs for a 5-lug, vented front left rotor

Installation Notes and Tips

Verify rotor dimensions before installation, including outside diameter, center hole diameter, bolt circle diameter, and thickness. This rotor is directional, so confirm left-side orientation and install only on the front left position listed in the fitment data. Inspect pads, caliper condition, and hub surface before assembly to help ensure proper rotor seating.

Quality Assurance

Dynamite Friction supplies this rotor with a rust-resistant coating and zinc black hat finish for improved surface protection. Confirm fitment against the vehicle application and rotor measurements before purchase. Part number 633-67049L should be matched to the exact front left application for 2002-2006 Nissan Altima, 2002-2004 INFINITI I35, and 2002-2003 Nissan Maxima.