Dynamite Friction 7002-13034 Disc Brake Rotor Set - Rear

Rear Brake Rotors for Subaru Forester

Dynamite Friction DFC Brake Rotors - Drilled and Slotted - Silver, part number 7002-13034, are built for rear brake service on 2014-2018 Subaru Forester models. This disc brake rotor set combines drilled holes and slots to improve pad bite, manage heat, and clear debris from the braking surface.

Key Features

• Fits 2014-2018 Subaru Forester, rear
• Drilled and slotted rotor design for stronger initial pad contact
• Drilled holes help reduce heat buildup during repeated braking
• Slots help sweep away brake dust and road debris
• Non-directional finish supports faster, more even pad bed-in
• GEOSPEC coated cast iron construction matched to OEM-style specifications
• 100% inspected for balance and critical dimensions

Product Details

The DFC Brake Rotors - Drilled and Slotted - Silver line is positioned as a performance-focused rotor family with OE-style fit, finish, and dimensional control. For Subaru Forester rear brake rotor replacement, part number 7002-13034 uses G3000/G11H18 cast iron and precision machining to support stable braking performance, quieter operation, and consistent rotor balance. The silver GEOSPEC coating adds corrosion resistance on non-friction surfaces while the machined braking face is prepared for proper pad seating.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Brake fade from heat buildup in repeated stops
• Reduced pad bite on wet or debris-covered roads
• Brake noise caused by uneven pad contact
• Pad glazing from trapped dust and road contamination
• Rotor vibration concerns related to balance or machining variation

Installation Notes and Tips

Install 7002-13034 on the rear axle only for the listed Subaru Forester fitment. Clean the rotor friction surfaces before installation, follow the vehicle service procedure for pad bedding, and verify caliper and pad condition before reassembly. Proper torque and a controlled break-in process help the rotor and pads seat evenly.

Quality Assurance

Each rotor is machined to tight tolerances, electronically mill-balanced when needed, and then inspected for critical dimensions before release. DFC backs this rotor set with a 12 month or 12,000 mile limited warranty against defects in material and workmanship.