Dynamite Friction 7002-42026 Disc Brake Rotor Set - Rear

Rear Drilled and Slotted Brake Rotors

Dynamite Friction DFC Brake Rotors - Drilled and Slotted - Silver, part number 7002-42026, are built for rear brake service on select Jeep Grand Cherokee and Dodge Durango applications. This disc brake rotor set uses drilled holes and slots to support more consistent braking response, especially in wet conditions and under repeated stops.

Key Features

• Rear disc brake rotor set for select Jeep Grand Cherokee and Dodge Durango vehicles
• Drilled and slotted design for improved pad bite and debris clearing
• Drilled holes help reduce heat buildup on the rotor surface
• Non-directional finish supports faster, more even brake pad bed-in
• GEOSPEC coated rotor construction for OE-style durability and corrosion resistance
• Machined to tight tolerances and 100% inspected for balance and critical dimensions
• Part number 7002-42026

Product Details

The DFC Brake Rotors - Drilled and Slotted - Silver line is positioned as a performance-focused rotor family with OE-spec engineering. These rotors are cast to G3000/G11H18 iron specifications, then machined and finished to promote stable braking, quieter operation, and smoother pad contact. For drivers searching for rear brake rotors for 2011-2020 Dodge Durango or rear brake rotors for 2014-2020 Jeep Grand Cherokee, this set provides a direct-fit solution for the listed applications. Part number 7002-42026 is also listed for 2021 Jeep Grand Cherokee rear and 2022 Jeep Grand Cherokee WK rear solid rear disc applications.

What It Helps Address

• Brake fade from heat buildup during repeated stops
• Reduced initial bite from worn or plain rear rotors
• Brake pad glazing and debris buildup on the rotor face
• Uneven pad bedding after rotor replacement
• Noise and vibration caused by worn rear brake rotors

Installation Notes

Verify rear axle configuration and rotor size before ordering, especially on Jeep Grand Cherokee models with solid rear disc setups and 330mm front rotor notes. Clean the hub mounting surface before installation and follow the vehicle manufacturer’s torque specifications. After installation, perform a proper brake pad bed-in procedure for consistent stopping performance.

Quality Assurance

Each rotor is inspected for balance and critical dimensions after machining. DFC also applies a 100% inspection process to confirm OE-spec requirements are met. This part number 7002-42026 includes a 12 month or 12,000 mile limited warranty against defects in material and workmanship.