Dynamite Friction 7002-72064 Disc Brake Rotor Set - Rear

Rear Drilled and Slotted Brake Rotors

Dynamite Friction DFC Brake Rotors - Drilled and Slotted - Silver are rear disc brake rotors built for Mitsubishi applications that need consistent braking performance and OE-style fitment. Part number 7002-72064 is a direct choice for drivers looking for drilled and slotted rear rotors for Mitsubishi Lancer and Mitsubishi Outlander models.

The DFC rotor line focuses on OE-matching construction with a performance-oriented surface design. These rear rotors use a drilled and slotted pattern to improve pad bite, help shed heat, and clear brake dust and road debris from the rotor face.

• Drilled holes help reduce heat buildup during repeated braking
• Slots help remove debris and reduce pad glazing
• Silver GEOSPEC coating helps protect the rotor surface
• G3000/G11H18 cast iron specification for OE-style durability and stability
• Non-directional finish supports faster, more even brake pad bed-in
• 100% inspected for balance and critical dimensions

Fitment and Application Details

• Fits 2009-2015 Mitsubishi Lancer, rear
• Fits 2007-2013 Mitsubishi Outlander, rear
• Fits 2008-2011 Mitsubishi Outlander, rear, 7 Passenger Vehicle

Use this rotor set when replacing worn rear brake rotors on a Mitsubishi Lancer or Mitsubishi Outlander and you want a drilled and slotted design for improved pad contact and heat management. The part number 7002-72064 is also a useful search reference when comparing rear brake rotor options for these vehicles.

What This Rotor Set Helps Address

• Brake pulsation from worn or uneven rear rotors
• Reduced braking response from glazed pads
• Heat buildup during repeated stops
• Brake dust and road debris on the rotor surface
• Moisture-related loss of initial bite in wet conditions

Installation Notes and Quality Assurance

Install on the rear axle only and verify vehicle configuration before ordering, especially for 2008-2011 Mitsubishi Outlander 7 Passenger Vehicle applications. Clean the rotor surfaces before installation and follow proper brake pad bed-in procedures after service. DFC machines each rotor to tight tolerances, applies a non-directional finish, and inspects every vented rotor for balance and critical specifications. DFC backs this part with a 12 month / 12,000 mile limited warranty against defects in material and workmanship.