Dynamite Friction 7002-76088 Disc Brake Rotor Set - Front

Drilled and Slotted Front Brake Rotors

Upgrade front braking performance with DFC Brake Rotors - Drilled and Slotted - Silver, part number 7002-76088. This disc brake rotor set is built for 1986-1992 Toyota Supra front and 1986 Toyota Celica front applications, with a design focused on consistent stopping response and OE-style fitment.

• Drilled holes help reduce heat buildup during repeated braking
• Slots clear brake dust and road debris from the rotor surface
• Silver GEOSPEC coating helps protect exposed areas of the rotor
• Machined to tight tolerances for stable, predictable operation
• Non-directional finish supports faster, more even pad bed-in
• 100% inspected for balance and critical dimensions

DFC Brake Rotors - Drilled and Slotted - Silver Line

The DFC Brake Rotors - Drilled and Slotted - Silver line is engineered around performance braking with OE-level dimensional control. These rotors use G3000/G11H18 cast iron and are machined to meet original equipment specifications for durability, reliability, and stability. For Toyota Supra and Toyota Celica owners searching for a front brake rotor set, 7002-76088 delivers a direct-fit solution with a finish intended to support quieter, smoother stops after proper pad bedding.

Vehicle Fitment

• Fits 1986-1992 Toyota Supra, front
• Fits 1986 Toyota Celica, front

Common Brake Issues Addressed

• Excessive rotor heat during repeated stops
• Brake pad glazing from debris buildup
• Uneven pad transfer on the rotor face
• Brake vibration caused by out-of-balance rotors
• Reduced wet-weather bite at the front axle

Installation Notes

Install 7002-76088 on the front axle only and verify rotor size and brake system match your vehicle before service. Clean the rotor surface before installation and follow a proper pad bed-in procedure to help achieve even contact and consistent braking. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Quality Assurance

Each rotor is inspected after machining, including balance correction when required, and then checked again for critical dimensions to confirm OE-spec compliance. DFC backs this rotor set with a 12 month or 12,000 mile limited warranty against defects in material and workmanship.