Dynamite Friction 7002-80028 Disc Brake Rotor Set - Front

Front Drilled and Slotted Brake Rotors

Dynamite Friction DFC Brake Rotors - Drilled and Slotted - Silver, part number 7002-80028, are built for 2007-2012 Mazda CX-7 front brake service. This disc brake rotor set uses drilled holes and slots to support stronger initial pad bite, better heat control, and cleaner rotor surfaces in demanding driving conditions.

Key Features

• Fits 2007-2012 Mazda CX-7, front
• Drilled and slotted rotor design for improved pad engagement
• Drilled holes help reduce heat buildup on the rotor face
• Slots clear brake dust and road debris from the pad surface
• Non-directional finish supports faster, more even pad bed-in
• GEOSPEC coated cast iron construction for OE-style durability and stability
• 100% inspected for balance and critical dimensions
• Part number 7002-80028 for ordering and fitment reference

Detailed Description

The DFC Brake Rotors - Drilled and Slotted - Silver line is focused on performance-oriented braking with OE-style fit and finish. For the Mazda CX-7 front axle, part number 7002-80028 is machined to tight tolerances, then finished with a non-directional surface to promote smoother stops and consistent pad contact. The drilled and slotted pattern is designed to help maintain braking response by venting heat and clearing debris from the rotor face.

DFC uses G3000/G11H18 cast iron specification rotors and applies a GEOSPEC coating to support durability and corrosion resistance. This makes the 7002-80028 a practical choice for drivers looking for a front rotor set for 2007-2012 Mazda CX-7 brake repair, replacement, or upgrade service.

What It Helps Address

• Brake fade from excess rotor heat
• Reduced stopping response in wet conditions
• Pad glazing caused by trapped debris and heat
• Uneven pad bedding after rotor replacement
• Rotor vibration concerns related to inconsistent machining

Installation Notes and Tips

Install on the front position only for the listed Mazda CX-7 applications. Clean the rotor surfaces before installation, verify pad condition, and follow the vehicle manufacturer’s torque and bedding procedures. For best results, replace pads if they are worn unevenly or show glazing before installing new rotors. Part number 7002-80028 should be matched to the front axle application shown in the fitment data.

Quality Assurance

Each rotor is inspected for balance and critical dimensions after machining, with electronic mill-balancing used when correction is needed. Final inspection checks OE specification targets for fit, finish, and consistency. DFC backs this rotor set with a 12 month or 12,000 mile limited warranty against defects in material and workmanship.