Dynamite Friction 7004-11024 Disc Brake Rotor Set - Front and Rear

Drilled and Slotted Brake Rotors for Range Rover Evoque

Dynamite Friction DFC Rotors-Drilled and Slotted-Silver, part number 7004-11024, are a front and rear disc brake rotor set for the 2012-2015 Land Rover Range Rover Evoque. This rotor set is built for drivers who want OE-style fitment with added braking response and heat management.

Key Features

• Fits 2012-2015 Land Rover Range Rover Evoque, front and rear
• Drilled holes help reduce heat buildup during repeated braking
• Slotted surface helps clear brake dust and road debris
• Silver GEOSPEC coating supports corrosion resistance on exposed surfaces
• Machined to tight tolerances for consistent rotor fit and finish
• Non-directional finish promotes even pad bed-in and smoother braking
• 100% inspected for balance and critical dimensions

Product Details

The DFC Rotors-Drilled and Slotted-Silver line is positioned as a performance-focused rotor family with OE-spec construction. For the Range Rover Evoque, part number 7004-11024 uses G3000/G11H18 cast iron and precision machining to match factory requirements for durability, stability, and reliable braking feel. The drilled-and-slotted design is intended to improve pad bite, reduce glazing, and maintain more consistent stopping performance in wet or demanding driving conditions.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues It Can Address

• Brake fade from heat buildup during repeated stops
• Reduced initial bite from worn or glazed pads
• Brake dust and debris buildup on the rotor face
• Uneven braking feel caused by rotor surface inconsistency
• Corrosion on exposed rotor surfaces

Installation Notes and Tips

Install 7004-11024 on the correct axle position for the 2012-2015 Land Rover Range Rover Evoque: front and rear. Inspect pads, calipers, and brake fluid condition before installation, and follow the vehicle service procedure for rotor replacement and pad bedding. Clean the rotor surface before use to remove any protective residue from packaging or handling.

Quality Assurance

Each rotor is inspected after machining, including balance correction where needed, and then checked again against OE specifications for critical dimensions. DFC backs this rotor set with a 12 month or 12,000 mile limited warranty against defects in material and workmanship.