Dynamite Friction 7004-13006 Disc Brake Rotor Set - Front and Rear

Drilled and Slotted Brake Rotors for Subaru Baja

Dynamite Friction DFC Rotors-Drilled and Slotted-Silver are built for drivers who want direct brake response and OE-style fitment. This disc brake rotor set is compatible with 2004-2006 Subaru Baja front and rear applications, including part number 7004-13006.

• Drilled and slotted rotor design for improved pad bite
• Helps reduce heat buildup during repeated braking
• Slots clear brake dust and road debris from the rotor surface
• Non-directional finish supports faster, more even pad bed-in
• GEOSPEC coated rotor construction for corrosion resistance
• Machined to tight tolerances and 100% inspected for balance and critical dimensions

Product Line Details

The DFC Rotors-Drilled and Slotted-Silver line combines performance-oriented rotor geometry with OE-matching engineering. These rotors use G3000/G11H18 cast iron specification and are machined to meet factory-style durability, reliability, and stability requirements for everyday street use.

Detailed Description

Part number 7004-13006 is a front and rear disc brake rotor set for the 2004-2006 Subaru Baja. The drilled holes help vent heat from the rotor face, while the slots help remove debris and reduce pad glazing for more consistent braking feel. This setup is a practical choice for Subaru Baja brake rotor replacement when you want a drilled and slotted design with OE-spec construction.

What It Helps Address

• Brake fade from heat buildup
• Uneven pad contact during rotor break-in
• Brake dust and debris accumulation on the rotor face
• Glazed brake pads
• Reduced stopping confidence in wet conditions

Installation Notes and Tips

Install on the correct axle positions for the 2004-2006 Subaru Baja, front and rear. Clean the rotor surfaces before installation and follow proper brake bedding procedures after service to help achieve smooth, quiet stops. Verify rotor orientation and inspect pads, calipers, and brake fluid condition during replacement.

Quality Assurance

DFC machines each rotor to tight tolerances, applies a non-directional finish, and inspects vented rotors for balance before final quality checks. Part number 7004-13006 is backed by a 12 month or 12,000 mile limited warranty against defects in material and workmanship.