Dynamite Friction 7004-44000 Disc Brake Rotor Set - Front and Rear

Drilled and Slotted Rotor Set for Hummer H1

The Dynamite Friction DFC Rotors-Drilled and Slotted-Silver rotor set is built for drivers who need direct braking response and consistent rotor performance. This Part Number 7004-44000 is a front and rear disc brake rotor set for 2002-2004 Hummer H1 models with 10,800 lb GVW.

Key Features

• Drilled and slotted design for improved pad bite and shorter stopping distance in wet conditions
• Drilled holes help reduce heat buildup during repeated braking
• Slots clear brake dust and road debris while helping reduce pad glazing
• G3000/G11H18 cast iron construction matched to OEM-style durability and stability
• Non-directional finish supports faster, more even brake pad bed-in and smoother stops
• 100% inspected for balance and critical dimensions after machining

Product Details

DFC Premium Performance Brake Rotors are machined to tight tolerances and finished to meet OE specifications for fit, durability, and braking consistency. The silver-coated DFC GEOSPEC rotor design is intended for drivers who want a performance-oriented replacement without moving away from factory-style reliability. Part Number 7004-44000 is a direct fit for the Hummer H1 braking system listed below.

Compatible With: Fits 2002-2004 Hummer H1, front and rear, 10,800 lb GVW. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues Addressed

• Brake fade from excess rotor heat
• Reduced stopping response in wet weather
• Brake pad glazing and uneven pad contact
• Rotor vibration caused by inconsistent machining or balance
• Brake dust and debris buildup on the rotor surface

Installation Notes

Verify rotor size, axle position, and GVW before installation. Clean the hub mounting surface, inspect pads and calipers for wear, and follow the vehicle service manual for torque and bedding procedures. Proper pad break-in helps the non-directional finish seat evenly.

Quality Assurance

Each rotor is inspected for balance and critical dimensions after machining to confirm OE-spec compliance. DFC backs this rotor set with a 12 month or 12,000 mile limited warranty against defects in material and workmanship.