Dynamite Friction 7004-45023 Disc Brake Rotor Set - Front and Rear

Drilled and Slotted Brake Rotor Set

Dynamite Friction DFC Rotors-Drilled and Slotted-Silver, part number 7004-45023, is a front and rear disc brake rotor set built for the 2013-2019 Cadillac XTS and 2014-2017 Buick Regal. The drilled and slotted design is made to improve pad bite, manage heat, and clear debris for more consistent braking in changing conditions.

This rotor set is engineered to OE specifications using G3000/G11H18 cast iron and a GEOSPEC coating for durability and stable fitment. The non-directional finish supports even pad bed-in and quieter, smoother stops. Part number 7004-45023 is a direct choice for drivers searching for Cadillac XTS drilled and slotted rotors or Buick Regal front and rear brake rotor replacement.

Key Features

• Drilled holes help reduce heat buildup during repeated braking
• Slots clear brake dust and road debris from the rotor surface
• Non-directional finish supports faster, more even pad bed-in
• GEOSPEC coated rotor construction for OE-style durability and stability
• 100% inspected for balance and critical dimensions
• Built to OE specifications for the 2013-2019 Cadillac XTS and 2014-2017 Buick Regal

Fitment Details

• Fits 2013-2019 Cadillac XTS, front and rear; excluding Coachbuilder Limo
• Fits 2014-2017 Buick Regal, front and rear

What It Helps Address

• Brake fade from heat buildup
• Reduced initial pad bite in wet weather
• Brake dust and debris accumulation on the rotor face
• Pad glazing from inconsistent rotor surface contact
• Vibration or uneven braking caused by rotor imbalance

Installation Notes

Verify rotor size and axle position before installation on your Cadillac XTS or Buick Regal. Clean the hub mounting surface, inspect pads and calipers, and follow proper pad bedding procedures after installation. This part number 7004-45023 is intended for front and rear rotor replacement where the listed fitment matches the vehicle.

Quality Assurance

DFC rotors are machined to tight tolerances, electronically mill-balanced when needed, and inspected at multiple stages to confirm critical dimensions and OE-spec compliance. DFC provides a 12 month or 12,000 mile limited warranty against defects in material and workmanship.