Dynamite Friction 7004-47050 Disc Brake Rotor Set - Front and Rear

Drilled and Slotted Brake Rotor Set

Dynamite Friction DFC Rotors-Drilled and Slotted-Silver, part number 7004-47050, is a front and rear disc brake rotor set built for 1994-1996 Chevrolet Caprice and 1994-1996 Chevrolet Impala applications. It is also listed for the 1994 Chevrolet Commercial Chassis with rear disc brakes. This rotor set is engineered for direct OE-style replacement with performance-focused venting and surface design.

The drilled and slotted design increases pad bite, helps shed heat, and clears brake dust and road debris from the rotor face. The silver GEOSPEC coating supports corrosion resistance, while the non-directional finish promotes even pad bed-in and smoother braking.

• Drilled holes help reduce heat buildup during repeated stops
• Slots clear debris and help resist pad glazing
• GEOSPEC coated cast iron construction for OE-spec durability
• Machined to tight tolerances for consistent fit and finish
• 100% inspected for balance and critical dimensions
• Non-directional finish supports quieter, more even pad bedding

Compatible Vehicle Applications

• Fits 1994-1996 Chevrolet Caprice, front and rear
• Fits 1994-1996 Chevrolet Impala, front and rear
• Fits 1994 Chevrolet Commercial Chassis, front and rear, rear disc

For shoppers searching for 1994-1996 Chevrolet Caprice brake rotors, 1994-1996 Chevrolet Impala drilled and slotted rotors, or a 7004-47050 rotor set for rear disc applications, this part matches those vehicle-specific needs. The part number 7004-47050 may also appear in catalog searches for the same application.

What This Rotor Set Helps Address

• Brake fade from heat buildup
• Reduced stopping consistency in wet conditions
• Rotor surface contamination from dust and debris
• Pad glazing during repeated braking
• Uneven brake feel from inconsistent rotor finish

Installation Notes and Tips

Verify rotor diameter, axle position, and brake configuration before installation. Clean the rotor faces before service and follow proper pad bedding procedures after installation. Inspect calipers, pads, and brake hoses at the same time to confirm the braking system is in good condition.

Quality Assurance

DFC machines each rotor to tight tolerances, applies a non-directional finish, and inspects vented rotors for balance before final quality checks. The rotor casting is produced to G3000/G11H18 cast iron specifications and is checked against OE requirements. DFC backs this part number 7004-47050 with a 12-month, 12,000-mile limited warranty against defects in material and workmanship.