Dynamite Friction 7004-54112 Disc Brake Rotor Set - Front and Rear

Drilled and Slotted Brake Rotors

Dynamite Friction DFC Rotors-Drilled and Slotted-Silver, part number 7004-54112, are a front and rear disc brake rotor set for select Ford heavy-duty applications. This set is built for 2003-2005 Ford Excursion, 2003-2004 Ford F-250 Super Duty, and 2003-2004 Ford F-350 Super Duty with single rear wheels.

The DFC Rotors-Drilled and Slotted-Silver line focuses on OE-style fit with performance-oriented rotor design. The drilled and slotted surface is made to improve pad bite, clear debris, and reduce heat buildup, while the silver GEOSPEC coating supports corrosion resistance on exposed rotor surfaces.

• Part number 7004-54112
• Front and rear disc brake rotor set
• Drilled holes help reduce heat buildup
• Slots clear brake dust and road debris
• Non-directional finish supports even pad bed-in
• Machined to tight tolerances for OE-style fit
• 100% inspected for balance and critical dimensions

Detailed Application Notes

These rotors are engineered from G3000/G11H18 cast iron and machined to meet OEM-style dimensional requirements for durability, reliability, and stable braking performance. For drivers searching for 2003-2005 Ford Excursion drilled and slotted brake rotors or 2003-2004 Ford F-250 Super Duty front and rear rotor replacement, this set provides a direct-fit solution. It also serves 2003-2004 Ford F-350 Super Duty single rear wheel brake rotor applications. Part number 7004-54112 is a practical choice when replacing worn rotors on Ford Excursion, Ford F-250 Super Duty, or Ford F-350 Super Duty trucks.

What It Helps Address

• Brake pulsation from worn or uneven rotors
• Reduced stopping response from glazed pads
• Heat buildup during repeated braking
• Brake dust and road debris accumulation on the rotor face
• Corrosion on exposed rotor surfaces

Installation Notes

Verify vehicle configuration before ordering: this set is listed for front and rear positions on the supported applications, with the F-350 Super Duty fitment limited to single rear wheels. Inspect pads, calipers, and hub surfaces during rotor replacement, and follow the vehicle manufacturer’s torque and bedding procedures for proper brake system service.

Quality Assurance

Each rotor is inspected for balance and critical dimensions after machining, and all finished rotors are checked to confirm OE-spec requirements. DFC backs this part with a 12 month or 12,000 mile limited warranty against defects in material and workmanship.