Dynamite Friction 8002-31098 Disc Brake Rotor Set - Rear

Drilled and Slotted Rear Brake Rotors

Dynamite Friction DFC Brake Rotors - Drilled and Slotted - Black, part number 8002-31098, are rear disc brake rotors built for BMW applications that use either original-design aluminum hat rotors or full cast rotor designs. This rotor set is listed for a wide range of BMW 5 Series and 7 Series models, including BMW 535i, 550i, 640i Gran Coupe, and 740Li rear brake applications.

The drilled and slotted surface is designed for consistent pad contact and a clean rotor face, while the black finish adds corrosion resistance and a more finished appearance behind the wheel. If you are replacing rear rotors on a BMW 640i xDrive Gran Coupe, 650i xDrive, or 740i, part number 8002-31098 provides a direct-fit option for the listed rear positions.

• Drilled and slotted rear disc brake rotor set
• Black-coated finish for added corrosion resistance
• Available for BMW rear brake applications with aluminum hat or full cast rotor designs
• Listed for models that use a disc brake pad wear sensor
• Rear-only fitment for the applications shown

Fitment Details

• Fits 2013-2019 BMW 640i Gran Coupe, rear
• Fits 2014-2019 BMW 640i xDrive Gran Coupe, rear
• Fits 2012-2018 BMW 640i, rear
• Fits 2014-2018 BMW 640i xDrive, rear
• Fits 2013-2018 BMW 650i Gran Coupe, rear
• Fits 2012-2018 BMW 650i xDrive, rear
• Fits 2013-2018 BMW 650i xDrive Gran Coupe, rear
• Fits 2010-2017 BMW 535i GT, rear
• Fits 2011-2017 BMW 535i GT xDrive, rear
• Fits 2012-2017 BMW 650i, rear
• Fits 2011-2016 BMW 535i, rear
• Fits 2011-2016 BMW 550i, rear
• Fits 2011-2016 BMW 550i xDrive, rear
• Fits 2011-2015 BMW 740i, rear
• Fits 2015 BMW 740Ld xDrive, rear
• Fits 2011-2015 BMW 740Li, rear
• Fits 2013-2015 BMW 740Li xDrive, rear
• Fits 2013-2015 BMW ActiveHybrid 7, rear

What These Rotors Help Address

• Rear brake pulsation from worn or uneven rotors
• Reduced braking consistency caused by heat buildup
• Visible rotor corrosion on BMW rear brake assemblies
• Noise or vibration associated with rotor wear
• Replacement needs for drilled and slotted rear rotor setups

Installation Notes

Confirm whether your BMW uses the original-design aluminum hat rotor or the full cast rotor configuration before ordering. This part is listed for rear position only, and some applications note a disc brake pad wear sensor. Match the rotor design and dimensions to the vehicle’s original rear brake setup for proper installation.

Quality Assurance

Dynamite Friction DFC Brake Rotors - Drilled and Slotted - Black are cataloged for specific BMW rear brake applications and built to original-specification fitment references where noted. Part number 8002-31098 is intended for the listed BMW 535i, 550i, 640i, 650i, and 740i rear applications.