Dynamite Friction 830-67105R Disc Brake Rotor - Front Right

Front Right Drilled and Slotted Rotor

The Dynamite Friction DFC Geoperformance Rotor - Drilled and Slotted, part number 830-67105R, is a vented front right disc brake rotor built for select Nissan and INFINITI applications. It features a 320 mm outside diameter, 28 mm nominal thickness, 26 mm discard thickness, and a directional slotted X drilled surface for consistent brake contact and heat management.

The Geospec Silver Grey hat finish and rust resistant coating help protect exposed surfaces, while the plain disc finish keeps the braking surface focused on performance. This rotor uses a 5-lug pattern with a 114.3 mm bolt circle and a 68 mm center hole diameter.

Key Features

• Part number 830-67105R for front right brake service
• Vented rotor construction with slotted X drilled surface
• 320 mm outside diameter and 49.2 mm overall height
• 28 mm nominal thickness and 26 mm discard thickness
• 5 bolt holes with 114.3 mm bolt circle diameter
• Rust resistant coating with Geospec Silver Grey hat finish
• Directional brake surface for the specified application

DFC Geoperformance Rotor Line

The DFC Geoperformance Rotor - Drilled and Slotted line is built for drivers who want a rotor with a performance-oriented surface pattern and corrosion protection on the hat area. For Nissan Z, INFINITI Q50, and related front brake applications, this rotor combines drilled and slotted geometry with vented construction to support repeatable braking performance under demanding street use.

Fitment

• Fits 2023-2025 Nissan Z, front right. Dual Piston Front, Single Piston Rear Calipers.
• Fits 2014-2024 INFINITI Q50, front right. Dual Piston Front Calipers.
• Fits 2015-2024 Nissan Murano, front right.
• Fits 2017-2022 INFINITI Q60, front right. Dual Piston Front Calipers.
• Fits 2013-2021 Nissan Pathfinder, front right.
• Fits 2014-2020 INFINITI QX60, front right.
• Fits 2016-2017 INFINITI QX50, front right.
• Fits 2013 INFINITI JX35, front right.

What It Helps Address

• Brake rotor wear on the front right corner
• Surface scoring or uneven braking feel
• Corrosion on exposed rotor hat surfaces
• Heat buildup during repeated braking
• Rotor replacement for drilled and slotted OE-style service

Installation Notes

Verify rotor dimensions, caliper configuration, and wheel fitment before installation. This rotor is listed for the front right position only, so match the vehicle side and brake setup exactly. Inspect pads, caliper hardware, and hub condition during service to confirm proper rotor seating and braking performance.

Quality Assurance

Dynamite Friction identifies this rotor as part of its Geoperformance line with rust resistant coating and a corrosion-protected hat finish. Part number 830-67105R is cataloged for direct application matching on the listed Nissan and INFINITI vehicles.