Dynamite Friction 830-76081L Disc Brake Rotor - Front Left

DFC Geoperformance Rotor for Front Left Fitment

The Dynamite Friction DFC Geoperformance Rotor - Drilled and Slotted, part number 830-76081L, is a vented front left disc brake rotor built for specific Toyota, Scion, and Pontiac applications. It combines a slotted X drilled surface with a rust resistant coating and Geospec Silver Grey hat finish for a clean, service-ready appearance.

Use this rotor when you need a direct replacement for the front left position on select Corolla, xD, Matrix, and Vibe models. The directional brake surface and 5-lug, 100 mm bolt pattern support the listed fitments with OE-style dimensions.

Key Features

• Part number: 830-76081L
• Part type: disc brake rotor
• Surface type: slotted X drilled
• Vented rotor construction
• Rust resistant coating: yes
• Hat finish: Geospec Silver Grey
• Disc finish: plain
• Outside diameter: 275 mm
• Nominal thickness: 22 mm
• Discard thickness: 19 mm
• 5 bolt holes / 5 stud-lug holes
• Bolt circle diameter: 100 mm
• Center hole diameter: 55 mm
• Directional brake surface

Product Details

The DFC Geoperformance Rotor line focuses on brake rotors with drilled and slotted friction surfaces for consistent pad contact and heat management in everyday driving and service replacement use. This rotor is specified for the front left position and matches the listed dimensions for vehicles that use a 275 mm vented rotor with a 100 mm bolt circle. The 830-76081L is a direct-fit option for drivers servicing a Toyota Corolla, Scion xD, Toyota Matrix, or Pontiac Vibe with the exact application shown below.

Fits 2019 Toyota Corolla, front left. Fits 2009-2018 Toyota Corolla, front left. Fits 2008-2014 Scion xD, front left. Fits 2009-2013 Toyota Matrix, front left. Fits 2009-2010 Pontiac Vibe, front left.

What This Rotor Helps Address

• Front brake rotor wear at the left side
• Rotor scoring or uneven friction surface condition
• Brake pulsation related to rotor thickness variation
• Corrosion on the rotor hat or exposed surfaces
• Replacement needs for drilled and slotted vented rotors

Installation Notes and Tips

Confirm rotor diameter, thickness, center bore, bolt pattern, and front left position before installation. Because this rotor uses a directional brake surface, install it according to the vehicle side and rotor orientation shown in the fitment data. Inspect pads, caliper hardware, and hub condition during brake service to help ensure even contact on the new rotor.

Quality Assurance

This rotor is built by Dynamite Friction for the DFC Geoperformance Rotor - Drilled and Slotted product line, with corrosion protection and application-specific dimensions for the listed vehicles. Part number 830-76081L is specified for the exact front left fitments shown above.