Elring 788.850 Exhaust Manifold Gasket

Exhaust Manifold Gasket for Jeep and Chrysler

Elring 788.850 is an exhaust manifold gasket for specific Jeep Liberty and Chrysler Voyager applications. It provides a direct sealing solution for exhaust manifold service where a tight, heat-resistant seal is required.

Key Features

• Exhaust manifold gasket for the exhaust sealing system
• Fits 2005-2006 Jeep Liberty, N/A
• Fits 2001-2003 Chrysler Voyager, N/A
• Elring part number 788.850 for identification and ordering
• Cross-references Monroe Shocks & Struts 172286 and 182286 for the same application

Detailed Description

Built for exhaust manifold sealing service, Elring 788.850 is used to restore the joint between the manifold and cylinder head on listed Jeep Liberty and Chrysler Voyager vehicles. This gasket helps maintain exhaust system sealing at the manifold connection, which is important for proper exhaust flow and leak control. If you are searching for an exhaust manifold gasket for 2005-2006 Jeep Liberty or 2001-2003 Chrysler Voyager, this part number is the direct reference to verify before purchase.

Common Uses

• Seals an exhaust manifold leak at the cylinder head interface
• Addresses exhaust noise caused by a leaking manifold joint
• Helps correct exhaust odor entering the engine bay
• Supports repair of gasket failure from heat cycling and age
• Restores sealing after exhaust manifold service on Jeep Liberty and Chrysler Voyager

Installation Notes and Tips

Confirm engine application and manifold design before installation, since fitment is listed only for the vehicles shown. Clean the mating surfaces thoroughly and inspect the manifold and fasteners for warpage, cracks, or corrosion before assembly. Use the vehicle-specific service procedure and torque sequence for the best sealing result.

Quality Assurance

Elring is a recognized sealing-system manufacturer, and part 788.850 is cataloged for the listed vehicle applications to support accurate replacement selection.