Elring 934.160 Fuel Injection Throttle Body Mounting Gasket

Fuel Injection Throttle Body Gasket

Elring 934.160 is a fuel injection throttle body mounting gasket built for precise sealing in the air and fuel delivery system. It uses FPM (fluoride rubber) construction with a 61 mm inner diameter and 4.5 mm thickness to help maintain a secure seal at the throttle body interface.

Fits 2016-2024 Porsche Panamera, N/A. Fits 2021-2022 Audi SQ5 Sportback, N/A. Fits 2021 Porsche Macan, N/A. Fits 2020 Audi S7 Sportback, N/A.

• Elring 934.160 throttle body mounting gasket for fuel injection sealing
• 61 mm inner diameter for the specified application
• 4.5 mm thickness for proper sealing surface engagement
• FPM (fluoride rubber) material for fuel-system sealing performance
• Cross-references OE-style part numbers 06M 133 237 A and 9A7 133 026 01 for the same application

Detailed Application Overview

This gasket is used at the throttle body mounting point to seal the joint between the throttle body and the intake side of the engine. On Porsche Panamera, Porsche Macan, Audi SQ5 Sportback, and Audi S7 Sportback applications, a correct sealing surface helps preserve stable airflow and fuel delivery at the throttle body connection. Elring 934.160 is identified by part number 934.160 and is specified for vehicles in the 2016-2024 range shown in the fitment data.

Common Problems This Part Addresses

• Air leaks at the throttle body mounting surface
• Fuel vapor or intake sealing loss at the gasket interface
• Rough idle caused by a compromised throttle body seal
• Reduced throttle response from an unsealed intake connection
• Service replacement for a worn or flattened throttle body gasket

Installation Notes

Inspect the throttle body and mating surfaces before installation and remove any residue, carbon buildup, or old gasket material. Verify the gasket dimensions match the application before assembly, and torque fasteners to the vehicle manufacturer’s specification. For best sealing results, install on clean, dry surfaces and confirm the throttle body seats evenly.

Quality Assurance

Elring manufactures sealing components for fuel system service, including injector O-rings and pump seals, with a focus on maintaining fuel pressure and flow. This part is built as a dedicated sealing component for the listed applications.